Knightsbridge KIT16 Instruction Manual

02
INSTALLATION & MAINTENANCE MANUAL
KIT16
IP
65
230V
50Hz
1

These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
KIT16W, KIT16B, KIT16WW
GENERAL INSTRUCTIONS
SAFETY
• This product must be installed in accordance with the latest edition of the IEE Wiring
Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified
electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this load is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this product when deciding the location for
installation
• This product series is IP65 rated
• This product is Class II double insulated
2

• When installing into decking, ensure there is enough clearance below so the fitting, cable, and
driver are not sitting in standing water
• Connect the cable from the secondary side of the driver to the first light in the installation with the
male and female plugs and sockets then connect remainder of the fittings in sequence
• Connect the cable from the primary side of the driver to a suitable power source ensuring correct
polarity is observed (Live (brown), Neutral (blue))
• Switch on power supply and check for correct operation
3
Fig. 2
INSTALLATION
Note: If this luminaire is being used in conjunction with external PIR or sensors, please confirm with
the manufacturer of the sensors that they are compatible with the lamp source
• Cut suitable 25mm holes in the mounting surface ensuring that they do not infringe with
electrical cables or water/gas pipes
• Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required ensuring the power source is via
an RCD or an RCBO
• The pre-installed cable supplied is for above-ground use only. Cables that are to be routed
within walls or below ground must be protected by means of suitable conduit or trunking
(see Fig. 1)
Fig. 1
• Feed the pre-installed cables through the holes and connect with the pre-installed
plugs and sockets (see Fig. 2)

ML Accessories Limited
LU5 4LT
www.mlaccessories.co.uk AKNOV18_V2
4
WARRANTY
This product has a warranty of 3 years from date of purchase. Failure to install in accordance with
the current edition of the IEE Wiring Regulations, improper use, or removal of the batch codes will
invalidate the warranty. If this product should fail within its warranty period it should be returned
to the place of purchase for a replacement. ML Accessories does not accept responsibility for any
installation costs associated with the replacement product. Your statutory rights are not affected.
ML Accessories reserve the right to alter product specification without prior notice.
WARNING
GENERAL
This product is unsuitable for installation in or near coastal and marine environments.
The product should be recycled in the correct manner when it reaches the end of its life. Check local
authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the product.
A light film of acid free oil is recommended after installation and maintained periodically
(2-3 times a year) to aid corrosion prevention
Note: the drainage below the luminaire should be able to drain the water away within 30 minutes
Do not use any source of high pressure washers to maintain or clean this product.
This product is non-dimmable
Driver supplied
This product has a cut-out of 25mm
This product must be disconnected from the circuit if subjected to any high voltage or insulation
resistance testing. Irreparable damage will occur if this instruction is not followed.