Koch VTC60 User manual

User manual
René Koch AG 044 782 6000
Seestrasse 241 044 782 6001 Fax
8804 Au/Wädenswil [email protected] BA VTC60 e 07.18
Indoor video intercom station VTC60
Ring-tones
Ring-tones sound different by calls from the entrance, the landing door or for an internal call.
The green LED lights up for 1 minute when there is a call by one of these sources.
The image is automatically displayed when there is a call at the door.

2/4
Overview of the device
*Smart-Slot = additional radio transmitter for a remote radio gong
Contrast
Brightness
Colour display
Unlock button
Blue LED on =
door is opening
Blue ambient lighting Speaker
Light button
Function button
Talk button
Green LED on =
incoming call or
talking mode is active
Smart-Slot*
Mute button
Red LED on =
mute is active
Volume button
for ring tone and call
Microphone
Colour saturation
Display button

3/4
Instructions for use
Answer a call •Press the talk button briefly; you now can talk without the need for
any further action (hands-free)
•If the talk button is pressed for more than 1 sec. the unit switches
to Press-to-talk mode (useful when surrounding noise is
disturbing): press talk button > talk / release talk button > listen
End a call •Press the talk button briefly. Talk mode also turns off automatically
after 60 sec. or 4 sec. after the unlock button has been pressed.
Unlock the door •Briefly press the unlock button
Turn on/off the door call •Press the mute button briefly: red LED on = door call off
Display image •Manually: Press the Display button briefly
Display switches on automatically with call at door
Switch off monitor display •Display shuts down automatically after 80 sec. or 4 sec. after
pressing the Unlock button (during talking mode)
Turn on the light •Press the light button
Control function 8 •Press the function button
(Setup default)

4/4
Settings
Programming the ring tones
1.) Switch on programming mode •Press the mute button for approx. 8 sec until you hear
a brief beep
•all the LEDs will light up
2.) Select ring tone •Select the ring tone by pressing the corresponding Ring
Tone Control button (see below) until you hear the one you
require (the unit stores the last ring tone to be selected)
Ring Tone Control buttons:
Unlock button •Ring tone setting for the entrance door 1 (AS 0)
Talk button •Ring tone setting for the entrance door 2 (AS 1-63)
Light button •Ring tone setting for the landing door
Function button •Ring tone setting for an internal call
Note •The ring-tones can be set in succession once the
programming mode has been activated
3.) End programming mode •The programming mode switches off automatically after 8
seconds of no activity
•A beep sounds; the LEDs go out
Setting the volume
Call volume •during a call, press the volume button repeatedly to select
the required volume for talking (default: level 3 of 4)
Ring tone volume •in idle mode, press the volume button repeatedly to select
the required volume for ring tone (default: level 3 of 4)
Blue ambient light •press the light button for 4 seconds to activate/deactivate
Additional functions to be programmed by your electrician, e.g.:
• parallel operation of several indoor intercom station
• blocking the ring tone selection
• internal conversation, call forwarding, door opener, etc.
Care
Clean the intercom unit with a dry or slightly damp cloth.
Use a household detergent to remove more stubborn stains.
Prevent any water from entering the unit!
Do not use any sharp or abrasive cleaning agents!
Subject to technical changes