Kodak i4000 Plus Series User manual

See the User’s Guide for feed module replacement
procedures.e
IMPORTANT:
The Roller Cleaning Pad contains sodium lauryl ether
sulfate which can cause eye irritation. Refer to the
MSDS for more information.
Staticide Wipes contain isopropanol which can cause
eye irritation and dry skin. Wash your hands with soap
and water after performing maintenance procedures.
Refer to the Material Safety Data Sheet (MSDS) for
more information (www.kodakalaris.com/go/MSDS).
Kodak Alaris Inc.
2400 Mount Read Blvd.
Rochester, NY 14615
A-61656 / Part #5K3537 July, 2014
© 2014 Kodak Alaris Inc. All rights reserved
The Kodak trademark and trade dress are
used under license from Eastman Kodak Company
i4000 Plus Series Scanners
Reference Guide
Replace pre-separation pad
Replace separation roller
Pre-separation Pad
Separation Roller
Supplies and Accessories
CAT No. Description
832 7538 Feeder Consumables Kit
838 7938 Extra-Large Feeder Consumables Kit
146 2415 Extra-Extra-Large Feeder Consumables Kit
834 8054 Image Guide Set (without Printer)
871 4438 Image Guide Set (with Printer)
808 8239 Flippable Background (without Printer)
800 0853 Flippable Background (with Printer)
896 5519 Staticide Wipes for Kodak Scanners
169 0783 Transport Cleaning Sheets
853 5981 Roller Cleaning Pads
840 5425 Printer Ink Blotters
818 3386 Enhanced Printer Black Cartridge
159 6832 Enhanced Printer Red Cartridge
CAT No. Accessories
844 5280 Feeder Kit for Ultralightweight Paper
809 6943 Enhanced Printer Accessory
189 4351 Kodak A3 Flatbed Accessory
183 3946 66.04 cm (26 in.) document extender
162 6803 76.2 cm (30 in.) document extender
148 8476 86.36 cm (34 in.) document extender
Kodak Service & Support
www.kodakalaris.com/go/disupport
1.800.822.1414
(US&C only; all other regions, contact your local
Kodak Support Center)
When contacting support, have the following available:
•A description of your problem
•Scanner model and serial number
•Computer configuration
•Software application you are using

Codes
Code LED Explanation
U1 Red Check the imaging guides
U2 Red Ink cartridge missing
U3 Red Increase document length setting
U4 Future use
U5 Red Timeout: USB disconnected
while scanner was running, etc.
U6 Red Scanner cover open
U7 Red • Too much paper is in the input
elevator
• The feed module is not inserted
properly
U8 Red Multifeed stop
U8 Green flash Multifeed pause
U9 Red Document jam or the paper path
is blocked
ERed flash • Be sure all cables are
connected properly
• Turn power off and then on
again
If problem persists, call Service.
Cleaning Frequency Chart
Procedure Start of
day Middle of Shift
Start of
new
shift
1Vacuum output tray and input areas (input
elevator and transport)
x
2Clean all rollers;
including feed module xx
3Run transport cleaning
sheet xx
4Clean imaging guides:
basic xxx
Clean imaging guides:
thorough (see User’s Guide)xx
Cleaning the transport and rollers Running a cleaning sheet and cleaning
the imaging guides
For detailed cleaning and replacement procedures see Chapter 5, Maintenance in the User’s Guide.