Before using, clip the device to an appropriately located air vent blade on the dashboard.
1. Connect the car’s dashboard power adaptor to the Type-C connector on the
device. The indicator light will illuminate in blue to show power is connected.
2. Ensure that the wireless charging surface and the rear of the mobile device are
unobstructed and free of metallic matter, then place the phone close to the
infrared sensor. The clamp arms will open and then retract automatically, gripping
the mobile device.
3. The LED indicator will display blue when the device is charging, and turn off when
fully charged. If the mobile device fails to charge properly, alter the height
adjustment so that the mobile device’s wireless charging coil is properly positioned
on the surface of the charging pad.
4. When the phone needs to be removed, touch the clamp release button on the left
side of the pad. The clamp arms will open automatically. (If the device is suddenly
powered off and the clamp arms cannot open automatically, the mobile device
can be directly removed from the arms.)
5. Touch the infrared button to turn off the infrared sensor. If the arms fail to open
automatically, touch this button twice to turn the infrared sensor off and on, and
the clamp should open when the device is brought close to the sensor as normal.
The scope of application is in accordance with wireless charging protocols and is
compatible with most mobile devices with a wireless charging function.
OPERATION
