Kogan KAHTP15WHTA User manual

1500W WHITE GLASS PORTABLE
ELECTRIC PANEL HEATER
KAHTP15WHTA

Read all instructions carefully before use.
•Make sure the voltage supplied matches the requirements indicated on the rating
plate of the heater.
•Do not operate this appliance if the cable or plug has become damaged.
•Keep the appliance and cable away from other sources of heat, sharp objects or
anything else that may cause damage.
•If the cord is damaged, it must be replaced by Kogan.com to avoid a hazard.
•Ensure the appliance is switched off before connecting to the mains power supply.
•Switch off the power supply at the switch and remove the plug from the outlet
when the heater is not in use, is being cleaned or undergoing any other
maintenance.
•To disconnect to heaters, switch it off, then remove the plug from the outlet. Do not
pull on the cord to disconnect the plug.
•The heater must not be located immediately below its power socket.
•Do not operate in areas where fuel, paint or any other flammable liquids are used or
stored.
•This heater is for indoor use only.
•To avoid overheating, do not cover the heater.
•To prevent a possible fire, never block the air intakes or exhaust vents in any
manner.
•Do not touch the hot surfaces directly.
•Do not insert or allow foreign objects to enter into any ventilation or exhaust
openings, as this may cause electric shock, fire or damage to the appliance.
•Always ensure that your hands are dry before operating or adjusting any switches
on the product or touching the plug and socket-outlet.
•This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
•Children should be supervised to ensure that they do not play with the heater.
•Do not leave the heater unattended when it’s in use.
•The most common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by disconnecting the appliance from
the power supply, then vacuum cleaning the air vents and grilles.
SAFETY & WARNINGS

•Do not place the heater on the carpet and don’t place the cable under carpets.
Arrange the cord away from traffic areas so that it will not be tripped over.
•Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
•Do not store away until the heater cools down, store the heater in a cool dry
location when not in use.
•The heater must not be used if the glass panel is damaged.
Warning - Keep Batteries Out of Reach of Children
•Swallowing may lead to serious injury in as little as 2 hours or death, due to
chemical burns and potential perforation of the oesophagus.
•If you suspect your child has swallowed or inserted a button battery immediately
call the 24-hour Poisons Information Centre on 13 11 26 for fast, expert advice.
•Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screw or other mechanical fastener is tightened. Do not use if the
compartment is not secure.
•Dispose of used button batteries immediately and safely. Flat batteries can still be
dangerous.
•Tell others about the risk associated with button batteries and how to keep their
children safe.

Part List
1. Decorative Glass
2. LCD Screen (blank when OFF)
3. Operation Buttons
4. Feet
5. Rear Cover
6. Power ON/OFF Switch
7. Power Cable
8. Sensor
9. Remote Controller
OVERVIEW

Free Standing
1. Attach the two plastic feet to the bottom of the heater and then fasten the feet to
the heater using a screwdriver and the provided screws. Each foot should be
secured with 4 screws.
2. Be sure to place the heater on a flat, stable surface.
Wall Mounting
Finding a suitable location
1. The device must be installed so that airflow is not obstructed. The wall mounting
should be performed by a qualified person to avoid hazards.
2. The minimum distances between the device and ceilings, ground and sidewalls, as
shown to the right, must be maintained.
ASSEMBLY
Min. 60cm
Min. 30cm
Min. 60cm
Min. 30cm

Installing and Fixing the Heater
1. Remove the wall brackets and expansion screws from the packaging and then fix
the screws to the wall according to the distances between the holes of the wall
brackets, as shown in the image below.
2. Aim the 4 holes in the back of the heater to the 4 hooks on the wall bracket and
push it on, then slide them into the slots to click on, as shown in the image below.
3. Fix the wall bracket lock piece onto the bracket with screws, slide the lock piece into
the locking slot on the back of the heater and then tighten the screw, as shown in
the image below.
Hook
Hook
Expansion Screw
Expansion Screw
Wall Bracket
Lock Piece

1. Connect the heater to a power socket and then switch the ON/OFF switch on the
side panel.
2. Press the buttons on the operation panel or remote control to set the heating.
3. Press the button on the heater and the machine will go into Standby Mode and
Frost- Free mode.
Press the power button “ ” to set to ECO mode, with displaying at Economic I
power or alternately “ ” displaying at Comfort II power or Frost-free mode “ ”
Flashing means the heater is in ECO mode
Flashing means the heater is at low power
Flashing means the heater is at high power
Flashing means the heater is in frost-free mode
Under heating status, the heating icon “ ” will appear on the LCD screen. Under
Frost-free status, if the ambient temperature is higher than 5°C, then the heating icon will
disappear.
Setting Temperature
The temperature can only be set under Comfortable or Economical mode. Under ECO and
Frost-free modes, the set temperature is fixed to 18°C and 5°C respectively. Press the
temperature button “ ”, then use the UP/DOWN buttons “ ” to set the temperature
between 15°C to 50°C. The setting will be memorised and confirmed after 10 seconds.
•When the ambient temperature is equal to the preset temperature, the power will
switch from Comfortable mode to Economical mode automatically.
•When the ambient temperature is 2°C higher than the preset temperature, the
heater will stop heating.
•When the ambient temperature is 2°C lower than the preset temperature, the
heater will switch to Comfortable mode again.
OPERATION

Timer Setting
Press the Timer Button “ ”, then use the UP/DOWN buttons “ ” set the timer from
0-24 hours. When the timer status is active, the “ ” timer symbol will flash. The setting
will be memorised and confirmed after 10 seconds.
If the timer is set while the heater is running, it will function to switch the heater OFF. If you
then set the timer to 01:00 while the heater is operating, it will switch off after one hour.
These functions may both be achieved using the remote control as well as the control panel.
Note:
The set temperature must be set to a temperature higher than the ambient
temperature; otherwise, the unit will not function.

1. Always disconnect the heater and let it cool down completely before any
maintenance.
2. Use a vacuum cleaner to remove dust and fluff from the grilles.
3. Clean the outside of the unit with a soft damp cloth and then dry it with a dry cloth.
Never immerse the unit in water, nor let water drip into the unit.
Overheating Safety Device
The heater is fitted with a safety device to switch it off in the event of overheating. If the
safety device has been triggered, please turn the heater off, unplug it and let it cool
completely. Inspect for blockages of the air inlets or outlets, attempting to restart the heater
after.
If the heater fails to operate or the safety device switches the heater off again, contact the
Kogan.com customer support team for further information.
Storing
1. Always disconnect the heater, allow it to cool and then clean it before storing it.
2. If you are not going to use the heater for an extended period, but the unit back into
its original carton and store it in a dry, well-ventilated location.
3. Do not place heavy items on top of the carton during storage as this may damage
the unit.
CLEANING & CARE

Rated Voltage
230V-
Frequency
50/60Hz
Rated Power
2000W
Protective Class
1
Disposal
This marking indicates that this appliance should not be disposed with other
house-hold wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.
SPECIFICATIONS

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com