Kogan NBLTSPBTMSA User manual

BATTERY POWERED WALL MOUNTED
MOTION SENSOR LED LIGHT
NBLTSPBTMSA

•Do not install the light close to people or cars. Keep out of reach of children.
•Do not install the unit close to flammable items.
•Do not stare directly into the light.
•When changing batteries, use only new 1.5V D-cell batteries.
Important information
The light is IP44 rated, meaning it is fully resistant to water splashes from any direction.
However, if the light is completely exposed to the elements and poor weather, some
penetration may be possible. If using outdoors, it is advised that you install the light in a
location with some protection, example an overhang of a roof, porch or garage.
1
Light and motion sensors
2
LED lights
3
Fixed base
4
Elevation control knob
5
Rotation control knob
SAFETY & WARNINGS
OVERVIEW

The wireless light is a powerful outdoor light with a durable ABS casing. The quadruple LED
display generates an impressive 600 lumens (8W) of bright white light, activated by a built-
in motion sensor.
This battery powered light requires no wiring, making for a quick and easy installation. The
body can also be rotated a full 360° to illuminate at your desired angle. Each activation lasts
30 seconds and a built-in light sensor prevents activation during daylight, conserving your
battery power.
Changing the batteries
1. Remove the front cover of the light by unscrewing in anti-clockwise direction (Figure
1), revealing the battery holder. Separate the battery holder by squeezing the two
tabs on the side and pulling (Figure 6).
2. Insert 4 x D-cell batteries into the holder (Figure 7), ensuring the correct polarity.
3. Reattach the battery holder by aligning the grooves on the side and clicking the
tabs into the inside of the holder (Figure 8). Screw the light back onto the holder
(Figure 1).
Figure 6
Figure 7
Figure 8
INSTALLATION
Note:
You do not have to remove the full fixture from the wall to change the batteries.

Mounting the light
1. The light requires 4 x D-cell batteries to be installed before use. Remove the cover
and install the batteries, being careful to install them in the correct polarity.
2. Reattach the front cover by aligning the grooves and screwing in clockwise
direction, as far as it goes. Make sure the arrow is pointing at the lock symbol to
ensure the waterproof seal is tight.
3. To wall mount your light, first remove the mounting base by turning the thumb
screw anti-clockwise (Figure 2).
4. Utilise the three holes to secure the mounting base to your desired wall, using the
screws provided (Figure 3). For best results and depending on your installation
location, consider drilling three pilot holes and using the wall plugs provided.
5. Insert the light unit back into the mounting base (Figure 4). You can now rotate the
light to a full 360° to achieve the desired angle, before tightening the thumb screw
in clockwise direction.
6. You can also pivot the light up and down to your desired angle by loosening the
upper thumb screw in anti-clockwise direction (Figure 5). Once the angle is set,
tighten the thumbscrew in clockwise direction.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5

•1 X Battery-Powered LED Sensor Light
•3 X Screws
•3 X Wall Plugs
IN THE BOX

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com