Kohler mira 1842.350.WH User manual

11367821-W2-A
These instructions must be left with the user
Mira Flight
Drop-In Bath
Installation and User Guide
Size Part No.
170 x 70 cm 1842.350.WH
170 x 75 cm 1842.351.WH
Size Part No.
180 x 80 cm 1842.352.WH

21367821-W2-A

31367821-W2-A
For best results, keep the following in mind when caring for your Mira product:
• Always test your cleaning solution on an inconspicuous area before
applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after
applying cleaner. Rinse and dry any overspray that lands on nearby
surfaces.
• DO NOT allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material
such as a brush or scouring pad to clean surfaces.
• Be careful not to leave staining materials in contact with the surface for
extended periods of time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water
from the surface after each use.
User Maintenance
• Warning! Appropriate safety apparel eg. gloves and safety footwear
must be worn.
• Make sure that the bath is installed by a competent installer.
• Shut o󰀨 the main water supply.
• Observe all local plumbing and building codes.
• Check for transit damage and report any faults immediately to your
supplier. No claims for the above will be considered after installation.
• Carefully remove all of the clear protective lm from the bath for inspection.
• Caution! Additional protective coverings such as a dust sheet should
then be used to protect the bath from damage from falling objects.
• Fitting this product is acceptance of quality.
• We guarantee this product against any defect in materials or workmanship
for a period of 10 years from the date of purchase.
Before You Begin

41367821-W2-A
Tools Required
Pack Contents
x 1
x 6
x 2
x 4
x 4
Ø 6mm

51367821-W2-A
90°
Installation
Install the adjustable feet on the underside of the bath.
Note: Ensure the legs are tted securely, adjust the legs to bring
the bath level.

61367821-W2-A
± 0 mm
Position the bath and adjust the feet to level. Mark the position of
the product.
+ 0 mm
Refer to Panel
Fixing Kit

71367821-W2-A
25 mm
25 mm
Ø 6mm
Install the drain and overow ttings according to the installation
instructions packed with the drain.
Mark and drill the xing holes for the brackets. Install the brackets
using the supplied wall plugs and screws.
11 mm Thick
Note: Make sure that
the overflow thread is
suitable for an 11 mm
thick bath

81367821-W2-A
Apply the sealant to wall sides of the product and place the product
on the previously installed brackets.
Caution! Baths are very heavy. Get assistance when moving or
lifting the bath.

91367821-W2-A
Connect the supply inlet pipes to the taps.

101367821-W2-A
Note: Check for leaks
Note: Check for leaks