Kohler 28139T-DR User manual

1299768-AN2-A 1
BEFORE YOU BEGIN
ROUGH-IN DIMENSIONS
28139T-DR Wall-Mount Dual Handle Lavatory Faucet Valve
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. An inline water filter must be used with this product.
3. Inspect the supply tubing for damage. Replace as necessary.
4. Observe local plumbing codes.
5. Check for leaks before covering the pipes, repairs as needed.
6. Please ensure only apply water pressure test on the product, and empty the air in pipe and faucet thoroughly
before the test. Please ensure test pressure below 0.8MPa(8bar) and test duration within 30 minute.
7. All installations should comply with the relevant requirements of AS/NZS 3500.
INSTALLATION INSTRUCTIONS
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
252
Ø35
Ø35~Ø38
Finished
Wall Ø34
Cold Water Inlet
G1/2˝
Hot Water Inlet
G1/2˝
53
68
200
280
78
Ø35~Ø45

1299768-AN2-A 2
SERVICE PARTS
INSTALLATION
1
3
1
2
3
The finished wall
51~61
1119280
1119281
1304918
73089
834851
**Color code must be specified when ordering.
Do not take off the protectors(1) at this moment.
Connect the G1/2" water supply pipes(2) to the supply yoke(3).
The distance from centerline of the water supplies to the surface of the finished wall must be between 51mm
and 61mm. Make sure the left supply pipe is the hot supply and connected to the end with red mark.