©2015 Kohler Co.
1042179-X2-D
Asia Customer Service Centre
No. 158, Jiang Chang San Road, Zhabei District, Shanghai, PRC Post Code 200436.
Tel: +(86) 21 2606 2572 Fax: +(86) 21 6107 8900
KOHLER (THAILAND) PUBLIC COMPANY LIMITED
16th FL. Jasmine City Bldg., 2 Soi Sukhumvit 23, Sukhumvit Road, Wattana, Bangkok 10110 Thailand
Call Center Tel. +(66) 2204 6222 Fax. +(66) 2204 6224
For best results, keep the following in mind when caring for your
product:
• Carefully read the cleaner product label to ensure the cleaner is safe
for use on the material.
• Always test your cleaning solution on an inconspicuous area before
applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately
after cleaner application. Rinse and dry any overspray that lands on
nearby surfaces.
• Do not allow cleaners to sit or soak on the surface.
• Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.
• Be careful not to leave staining materials in contact with the surface
for extended periods of time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any
water from the surface after each use.
WARNING: Risk of property or product damage. Do not
use in-tank cleaners in your toilet. Products containing
chlorine (calcium hypochlorite) can seriously damage fiings
in the tank. This damage can cause leakage and property
damage.
Troubleshooting Care and Cleaning
การดูแลรักษาและการทําความสะอาด
Symptoms Recommended Action
1. Poor flush. A. Adjust the tank water level to match the
waterline.
B. Fully open the water supply shut-off valve.
C. Clear obstructions from the trapway, jet, or bowl
rim holes.
D. Clear obstructions from the waste line.
2. No flush. A. Reconnect the flapper chain to the trip lever or
flush valve.
B. Adjust the flapper chain assembly to
remove excessive slack.
3.
The fill valve
A. Adjust the flapper chain for proper slack so the
turns on/off
flapper closes.
by itself B. Clean or replace the flapper if it is worn, dirty, or
without the misaligned with the opening.
toilet being
C. Clean the area around the opening to allow
flushed, or it
the flapper to seal.
runs, allowing
D
. Adjust the tank water level if it is too high.
water to enter
E. Replace the fill valve if the valve float sinks.
the tank.
F. Adjust the tank water level if it is too high.
4. Tank takes A. Fully open the water supply shut-off valve.
excessive time
B. Check the flexible supply line (if applicable) for
to fill. a kink. Remove the kink.
C. Clean the valve inlet, valve head, or supply line.
Flush the lines.
5. There is A. Partially close the water supply shut-off valve if
excessive the waterpressure to the toilet is too high.
noise when Check the toilet performance following any such
the tank adjustment.
is filling. B. Remove dirt or obstructions from the valve head.
Flush the lines.
6. Trip arm A. Adjust flush ball chain assembly to remove
strikes excessive slack.
tank lid B. Adjust trip arm bracket and flange so they
underside. are parallel with tank top.
ปญหาที่พบ วิธีการแกไข
1.
2.
ขอแนะนําการแกไขปญหาเบื้องตน
•
•
•
•
•
•
•
ขอควรระวัง ความเสี่ยงซึ่งอาจกอใหเกิดความเสียหายกับที่พัก
อาศัยและสุขภัณฑ
