Kohler K-77713W-Y Assembly instructions

1290970-GL2-B ©2017 Kohler Co.
Installation and Care Guide
Two Piece Toilet
EN
p3
Installation and Care Guide
Two Piece Toilet

Kohler Co. 3 1290970-GL2-B
Thank You for Choosing Kohler Company
ȱ ¢ȱ ȱ ȱ ǯȱ ȱ ȱ ěȱ ¢ȱ ȱ 
combination of proven performance and graceful sophistication that will
satisfy you for years to come. The dependability and beauty of your Kohler
product will surpass your highest expectations. We’re very proud of our
products here at Kohler and we know you will be too.
Please take a few minutes to review this manual before you start installation. If
you encounter any installation or performance problems, please don’t hesitate
to contact us. Our phone numbers and website are listed on back cover.
All information in this manual is based upon the latest product information
available at the time of publication. At Kohler, we constantly strive to improve
the quality of our products. We reserve the right to make changes in product
characteristics, packaging or availability at any time without notice.
Thank you for choosing Kohler Company.
Important Information
IMPORTANT NOTICE TO INSTALLERS!: Please leave these instructions for
the consumer. They contain important information.
In addition to installation procedures, this manual contains important care and
cleaning. Please retain for future reference.
NOTE:Ȳȱȱȱȱȱȱǯ
NOTE:Ȳȱȱȱȱȱȱȱ¢ȱěȱȱȱ
being installed.

1290970-GL2-B 4 Kohler Co.
Before You Begin
CAUTION:ȹR  p ¢  p ǯ Handle with
care. Product can break, chip, or cause injury if handled carelessly.
CAUTION: R  p ¢ǯ Turn on the water and allow water
ȱĚȱȱȱ¢ȱȱȱĚȱȱ¢ȱȱ¢ȱȱȱ
ȱęȱǯ
Observe all local plumbing and building codes.
Prior to installation, unpack the new lavatory and inspect it for damage.
Return the product to its protective carton until you are ready to install it.
Use the template supplied with the product.
Failure to follow these precautions may result in a poor installation.
ȱ ȱȱ¡ȱȱȱȱȱȱ¢ȱȬěȱȱȱȱǰȱ
install one before installing the new toilet.
Fixture dimensions are nominal and conform to tolerances established by
ȱȱŝşŘȬŘśśŚǰȱȦȱŗŗŘǯŗşǯŘȦŚśǯŗǰȱŜşśŘȬŘŖŗśǰȱ
ŗŗŝŘǯŗȬŘŖŗŚǰȱDZȱşşŝȬŘŖŗŘǰȱŗśśŘDZŘŖŗŗǰȱȱśŝŚDZŘŖŗŘǰȱȱŖřȬŖŝşŝDZȱ
ŘŖŖŜǰȱȱŗśŜDZŘŖŗŖȱȱȬŗŚŝřȬŘŖŗŜǯ
ȱ ȱȱȱȱDZȱȱȱȱȱȱȱ
ȦȱřśŖŖȱȱȦȱŜŚŖŖǯ
Tools

Kohler Co. 5 1290970-GL2-B
Roughing-in
Connector to Wall (P-trap)
Back to Wall Toilet
Connector to Floor (S-trap)
Install the supply and outlet to conform to the roughing-in dimension.
P-Trap
Model Number Roughing-in (mm)
K-77713W-Y 185
K-78316K 185
K-78317K 185
K-78470K 185
K-78472K 185
UJO102 185
S-Trap
Model Number Roughing-in (mm)
K-20614X 305
K-77766A 90-160
K-78318K 305
K-78319K 305
K-78469A 90-160
K-78799K 305
K-78800K 305

1290970-GL2-B 6 Kohler Co.
Connector to Wall (P-trap)
Non-Back to Wall Toilet
Connector to Floor (S-trap)
P-Trap
Model Number Roughing-in (mm)
K-77715W-Y 185
K-77766K 185
K-77793H 185
K-78476H 185
K-78478K 185
K-78480R 185
K-78765R 185
UJP102 185
S-Trap
Model Number Roughing-in (mm)
K-77769R 225
K-77787H 225
K-78475H 225
K-78477K 225
K-78479R 225
K-78766K 225
K-78767H 225
K-78846H 225

Kohler Co. 7 1290970-GL2-B
Installation
Position the template on the floor to
ensure the template against the wall.
Position the brackets as shown on the
template and install the brackets.
6JTGCFVJGUWRRN[JQUGQPVQſNNXCNXG 2QUKVKQPVJGICUMGVQXGTVJGHNWUJXCNXG
nut.
Tape in place and drill holes.
10 mm
Draw centerline
on the floor.
12
34

1290970-GL2-B 8 Kohler Co.
Installation
5Install the tank onto the bowl with tank fixing kit.
Type 1
Remove the canister
from the base with turn
counter-clockwise or
clockwise and lift up.
Type 2
Type 3
1
2

Kohler Co. 9 1290970-GL2-B
Installation
8
7
9
64GKPUVCNNVJGƀWUJXCNXGDQF[D[RTGUUKPIKVſTON[QPVQVJGDCUG
Position the full mark on the
HWNNƀWUJDWVVQPUKFG
Install inlet plug in tank if needed.
5NKFGVJGJQUGIWKFGQPVQVJGJQUGYKVJVJGƀCTGFGPFNCUV5NKFGVJGVYQKPUGTVU
KPVQVJGƀCTGFQHVJGJQUGIWKFG
#VVCEJKPNGVRNWIQPUKFGQHDQYN
(Optional for left or right side)
Full FlushHalf Flush

1290970-GL2-B 10 Kohler Co.
Installation
10
Connect the connector on the bowl. Carefully tilt backward until connector and
waste pipe touch.
Connector to Wall
Connector to Floor
#NKIPEQPPGEVQTCPF
ECTGHWNN[NQYGTQXGT
brackets. Install floor
OQWPVKPIMKV
12 Connect supply and
turn on the water. 13 Caulk silicone around
base.
Caulk
11

Kohler Co. 11 1290970-GL2-B
Installation
123467895
12 3
Rest the end of rods
10 mm.
Screw the rods into the rod
holes.
4
Record the height of rods.
(X= measure from the top
QHƀWUJXCNXGDQF[VQTKO
mouth of push button hole)
X
X-55 mm
10 mm
Remove the rods from
push button.
Install the Push Button
5Install the push button
into the push button hole.
6
78
Calulate the height of
rods by the record height
rods minus 55 mm. Cut
excess of rods.
Assemble the sleeve
and tighten with screws.
Install the tank cover. 9Press the push buttons
for testing.
X-55 m
m
12 34 678910 11 125
1
0 m
m
12 34 67 895

1290970-GL2-B 12 Kohler Co.
Complete Installation
Care and Cleaning
ȱȱǰȱȱȱȱȱȱȱȱȱ¢ȱDZ
• Carefully read the cleaner product label to ensure the cleaner is safe for use
on the material.
• Always test your cleaning solution on an inconspicuous area before applying
to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after
cleaner application. Rinse and dry any overspray that lands on nearby
surfaces.
• Do not allow cleaners to sit or soak on the surface.
Ȋȱ ȱȱǰȱȱȱȱǯȱȱȱȱȱȱȱ
a brush or scouring pad to clean surfaces.
Ȋȱ ȱ ȱ ȱ ȱ ȱ ng materials in contact with the surface for
extended periods of time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water
from the surface after each use.
Flush several times and check for leaks.
Do not overtighten!
Install the seat.
12

Kohler Co. 13 1290970-GL2-B
S¢p R A
ŗǯȱ ȱĚǯ A. Adjust the tank water level to match the waterline.
ǯȱ¢ȱȱȱȱ¢ȱȬěȱǯ
C. Clear obstructions from the trapway, jet, or bowl
rim holes.
D. Clear obstructions from the waste line.
Řǯȱ ȱĚǯ ǯȱȱ ȱ ȱ ȱ Ĵȱ ȱ ȱ ȱ ǯȱ
Adjust as needed.
řǯȱ ȱęȱ
ȱ ȱȦěȱ¢
itself or it runs,
allowing water
to enter the tank.
ǯȱȱȱĴȱȱȱȱȱȱȱ
ĚȱȱȱȂȱȱěȱȱĚȱǯ
ǯȱȱȱȱȱĚȱȱȱȱȱȱǰ
ȱ ¢ǰȱȱȱȱȱȱȱȱĚȱ
valve seat is damaged.
ǯȱȱȱȱȱȱȱĚȱȱȱ
ȱ Ěȱȱȱȱǯȱȱȱǯȱ
If leakage continues, replace the gasket.
ǯȱȱȱęȱȱȱȱȱȱȱȱ
seal assembly.
ǯȱȱȱęȱȱȱȱȱĚȱǯ
Śǯȱ ȱȱę
cycle.
ǯȱ¢ȱȱȱȱ¢ȱȬěȱǯ
ǯȱȱȱȱǰȱȱǰȱȱ¢ȱǯ
Flush lines.
śǯȱ ¢ȱȱę
cycle.
ǯȱ¢ȱ ȱ ȱ ȱ ¢ȱ Ȭěȱ ȱ
if the water pressure to the toilet is too high.
Check the toilet performance following any such
adjustment.
ǯȱȱȱȱȱȱȱȱǯȱ
Flush lines.
Troubleshooting Guide