Kool-It KCB-60-2 Operating instructions

Chef Bases
KCB-60-2
KCB-74-4
KCB-83-4
KCB-96-4
Visit us on the web at www.mvpgroupcorp.com

Contents
♦Specifications ………………………………....
♦Installation …………………………………….
3
4
♦Maintenance & cleaning ……………………..
♦Operation & Installing Castors ………….....
4
5
♦Trouble-Shooting …………………………….. 6
Visit us on the web at www.mvpgroupcorp.com

Pdt
Ch f B
Specifications
P
ro
d
uc
t
Ch
e
f
B
ases
Model KCB-60-2 KCB-74-4 KCB-83-4 KCB-96-4
(96M-4)
Capacity (cu.ft) 9.8 14.3 17.2 21.4
W
73
83 3
96 1
Exterior Dimensions
(Including 4”Casters)
[in]
W
60.0
73
83
.
3
96
.
1
D 32.5 32.5 32.5 32.5
H25.1
(25.5)
25.1
(25.5)
25.1
(25.5)
25.1
(25.5)
NtWiht(lb)
304
342
364
N
e
t
W
e
i
g
ht
(lb
s
)
231
304
342
364
Rated Voltage AC115V /60Hz
Type of Power Cord NEMA 5-15
Amps 3.0 3.0 3.5 3.5
Compressor (HP) 1/5 HP 1/5 HP 1/4 HP 1/4 HP
Drawers 2 44 4
Vessel - Pan Quantity
(Full size pan) 6 8 10 12
Refrigerant R-290
Range of Temperature 32~40°F
♦Specifications and Designs are subject to change without notice.
♦
The name plate (including Serial No.) is located on the upper left side of the cabinet interior.
♦
The
name
plate
(including
Serial
No.)
is
located
on
the
upper
left
side
of
the
cabinet
interior.
3
Visit us on the web at www.mvpgroupcorp.com

Installation
1. INDOOR USE ONLY
•This unit is intended for indoor use only.
2. FOR LOCATION
•Be sure that the location is strong enough to support the total weights of the unit and the content.
•Keep the unit away from sunlight and other heat generating equipment.
•The minimum clearance between the back of the unit and the wall should be 7 inches at least.
3. INSTALLING CASTORS
3. INSTALLING
CASTORS
•Be sure that castors with brake should be installed in front.
4. LEVELING
•The unit should be leveled to provide adequate drainage.
5. ELECTRICAL CONNECTION
•The unit should be plugged into a 115V/60Hz, grounded wall receptacle to
prevent electrical shock and fire hazards.
•
Do not plug other electrical units into same wall receptacle this unit is plugged into
Maintenance & Cleaning
•
Do
not
plug
other
electrical
units
into
same
wall
receptacle
this
unit
is
plugged
into
.
•Do not use an extension cord.
•Compressor warranties are void if the compressor burns out due to low voltage.
Maintenance & Cleaning
1. To maintain proper refrigeration performance, the condenser fins should be
checked monthly and clean with a soft brush or vacuum cleaner as needed.
2. Wait at least 6mimutes after unplugging the unit before plugging in.
3. The interior and exterior of the unit can be cleaned using plugging in water.
•Do not use an abrasive cleaners to avoid scratches on the surfaces.
4. The door-gasket should be cleaned to avoid maintain proper sealing.
4
Visit us on the web at www.mvpgroupcorp.com

Operation
1. The tem
p
erature controller
(
thermostat
)
is located on the u
pp
er
p() pp
left of the back side of the cabinet interior.
2. The controller has been preset "NORMAL" position at the factory.
3. Set the control-knob toward "COOL" for higher temperature and
"COLD" for lower temperature.
4. The thermostat controls compressor's ON/OFF by sensing inside
temperatures of cabinet
temperatures
of
cabinet
.
5. The unit is equipped with an off-cycle defrost .
Installin
g
Caster
s
g
1. Remove the outer packing.
2. Install the castors in the area.
3Mk h ihb k h ldb i lldi f
3
.
M
a
k
er sure t
h
at castors w
i
t
h
b
ra
k
es s
h
ou
ld
b
e
i
nsta
ll
e
d
i
n
f
ront.
5
Visit us on the web at www.mvpgroupcorp.com

Troubleshooting
Problem Possible Cause Action
Compressor
will not start
Power connection failure. Check Power Cord and plug it in.
Power switch is in off position. Change it on position.
Temperature
set
point
is
too
high
.
Correct
temperature
set
point
.
The unit does not
refrigerate well
Temperature
set
point
is
too
high
.
Correct
temperature
set
point
.
The door is opened too frequently. Do not open the door
Frequently.
Loading of too much warm or
moist product. Do not load warm or moist product.
Move
the
unit
in
a
well
Not enough ventilation.
Move
the
unit
in
a
well
ventilated place with at least 7
inches of clearance on all sides.
Condenser is clogged. Clean it.
Condensation
on cabinet exterior High moisture air can produce dews during the rainy season. Wipe with cloth.
※The following is not an indication of problem or malfunction;
A
water-flowing sound can be heard when the unit is operating.
This is the sound of refrigerant flowing.
6
Visit us on the web at www.mvpgroupcorp.com

MEMO
Visit us on the web at www.mvpgroupcorp.com

MVP GROUP CORPORATION
5659 Royalmount Ave.
Montreal, QC, CanadaMontreal, QC, Canada
H4P 2P9
Telephone : [phone]
Toll Free Telephone : [phone]
FFaax : (514) 342x : (514) 342-38543854
Toll Free Fax : [phone]
Email : s[email protected]
Website : www.mvpgroupcorp.com
Visit us on the web at www.mvpgroupcorp.com
12000 Biscayne Blvd. Ste 108
Miami, FL United States
33181
(786)-600-4687
(844)-218-8477
(786)-661-4100