Korpinen 21273109-00 User manual

D012225
Manual
21273109-00 Manual Gaius Original basin
lifter installation guide

D012225
Manual
Description
ID
Item Revision
D012225
A.2
Type
Installation instructions
Subject
Owner
korpinen_admin
Owning Group
Korpinen

D012225
Manual
1
Symbols used in this manual
Warning!
Indication of potentially hazardous situation. If not
avoided, it can result in serious injury or death.
Caution!
Indication of potentially hazardous situation which may
result in minor or moderate injury.
It may also be used to alert against unsafe practices.
Notification!
This symbol is used to notify correct use and handling of
the product.
General safety
This manual must be read and understood before use and
installation. Always keep this manual in close proximity of
the product.
The use, installation and service of this product must follow
this manual to avoid accidents and serious personal injury.
Never use or handle this product in other ways specified in
this manual as it can result in personal safety hazards and/or
cause damage to the product.
Persons installing and/or using this product either as
operator or user should have the necessary safety
information and access to this manual.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or duly qualified designated
persons in order to avoid a hazard.

D012225
Manual
2
Do not perform unauthorized repairs, disassembly or
assembly operations, add-ons, re-adjustments or
modification of the product beyond what is described in
this manual. Any use, modification or adjustment not
described in the most recent approved revision of the
manual is strictly forbidden. Do not perform service while the
product is connected to the mains power.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given adequate supervision or instruction
concerning the safe use of the appliance and they
understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall
not be performed by children without supervision.
Do not use the product if it has defects or signs of damage
are present. If the device makes unusual noise or smells,
switch off the mains voltage immediately.
Take care that the cables are not damaged. Unplug the
mains cable on mobile equipment before it is moved.
The products must only be used in an environment that
corresponds to their IP protection.
The information in this manual is based on correct
installation in accordance with installation instructions for
this product.
Korpinen cannot be held liable if the product is used in any
way that differs from stated in this manual and/or
installation instruction. Korpinen reserves the right to amend
this manual and reference documents without prior notice.

D012225
Manual
3
Product label symbols
This product is CE-marked in accordance with:
Council Directive 2006/42/EC on machinery
Council Directive 2011/65/EU, RoHS
Manufacturer name and address
Date of production
Stock number
Serial number
Consult manual before use
Operating interval of electrically operated equipment. The use of
electrical height adjustable equipment can run at maximum 2
minutes, followed by an 18-minute break.
Type B applied part. The product complies with IEC 60601-1
requirements to provide protection against electric shock.
Consult manual for important safety related information, warnings,
and safety precautions.
Class II, double isolated electrical components.
Do not dispose as unsorted municipal waste. Product must be
returned to a designated recycling station.
Mobile phones or other portable RF emitting equipment should be no
closer to the product than 30cm.
Operating and storing temperatures may not exceed 5-40°C

D012225
Manual
4
Exploded view
1 pcs. Lifting unit
1 pcs. 6203
Original basin
(Sold separate)
1 pcs. Bottom
cover
1 pcs. Top cover
1 set Basin
support arms
1 pcs. 13982
Drain pipe (sold
separate)
1 pcs. Faucet
with 10mm inlet
tubing (Sold
separate)
1 pcs. Crank

D012225
Manual
5
Figure 1. Water inlet, drain and mounting hole placement
Water inlet
Drain area

D012225
Manual
6
Figure 2. External dimensions and reinforced area (Plywood 20 mm with full thread screws)

D012225
Manual
7
1. Install the basin support arms and tighten the mounting
screws
Make sure the support
arms are mounted as far
as they will go.

D012225
Manual
8

D012225
Manual
9
2. Predrill all necessary holes. Refer to Fig. 2 for mounting
hole positions. Install the top mounting screws into the
wall.
IMPORTANT NOTICE!
Please leave a 10mm
gap between the wall
and the screw head.
Refer Fig. 2 for hole
positions.
NOTICE! Mounting
hardware not included
Korpinen part no. 6219-Z
NOTICE! If the wall
material requires the
use of a wall plug,
silicone caulk should
be used in the holes.

D012225
Manual
10
3. Lift the basin lifter on top of the top screws in the wall.
Using a spirit level, ensure that the unit is installed level.

D012225
Manual
11
4. When the unit is level, tighten the top screws; insert and
tighten the bottom screws. Plug the lifter to mains power
and test the lifter before adhering the basin.
IMPORTANT NOTICE! Use
a spirit level to ensure
the unit is installed level
IMPORTANT NOTICE! Test
the unit before moving
to the next step.
IMPORTANT NOTICE! While testing, keep hands
and tools away from the open mechanism.

D012225
Manual
12
5. Assemble the faucet, basin and plumbing
NOTICE! Cut the air lock
plumbing to size
NOTICE! 13982 Flexible
drain pipe sold separate.
NOTICE! Air lock must
be pressed and fixed
to the top position
with a cable tie.
Flexible drain pipe
must be held in place
with hose clamp.
NOTICE! Move the air
lock O-ring to the rear
notch
IMPORTANT NOTICE!
The faucet tubes must
be 10mm in diameter.
Cut the faucet tubes
to the specified
length.

D012225
Manual
13

D012225
Manual
14
6. After testing the unit and cleaning the underside of the
basin, adhere the basin to the lifter frame and install the
plumbing.
IMPORTANT NOTICE! The
bond will be permanent
Use Sikaflex FC11 to
adhere the basin
IMPORTANT NOTICE! Make
sure to leave a 5 –8 mm
gap between the basin
and any walls next to it

D012225
Manual
15
2x Hose
brackets
NOTICE! 13970 Water hoses, connectors and brackets package (sold separate)
contains: 2 pcs. Hose L500 G1/2, 2 pcs. G1/2 10mm Cut-off valves and 2 pcs. Hose
brackets
2x G1/2 10mm
Cut-off valve
Hoses: L500 G1/2
or Total L650-
700mm
Wall or floor
drain area
Water inlet must point towards
the floor and it must not
protrude more than 45 mm
Always use hose clamps with
the flexible drain tube.
IMPORTANT NOTICE! Floor drain tube diameter 32 –40 mm. Center distance from wall
50 - 60 mm. Recommended floor drain height 235 mm.

D012225
Manual
16
7. Install the bottom cover
IMPORTANT NOTICE!
Mind the bottom
screws when sliding
the bottom cover to
place; remember to
tighten the bottom
screws.

D012225
Manual
17
8. Install the top cover.
IMPORTANT NOTICE!
You may omit this
side screw if the
screw cannot be
reached.

D012225
Manual
18
9. Install the crank and perform a final test of the unit