Korpinen Gaius Original 21273106-00 User manual

D012222
Manual
21273106-00 Electric Gaius Original basin
lifter installation guide

D012222
Manual
Description
This document describes the installation process and hole placements for the 21273106-00
Electric Gaius Original basin lifter.
ID
Item Revision
D012222
A.2
Type
Installation instructions
Subject
Owner
korpinen_admin
Owning Group
Korpinen

D012222
Manual
Symbols used in this manual
Warning!
Indication of potentially hazardous situation. If not
avoided, it can result in serious injury or death.
Caution!
Indication of potentially hazardous situation which may
result in minor or moderate injury.
It may also be used to alert against unsafe practices.
Notification!
This symbol is used to notify correct use and handling of
the product.
General safety
This manual must be read and understood before use and
installation. Always keep this manual in close proximity of
the product.
The use, installation and service of this product must follow
this manual to avoid accidents and serious personal injury.
Never use or handle this product in other ways specified in
this manual as it can result in personal safety hazards and/or
cause damage to the product.
Persons installing and/or using this product either as
operator or user should have the necessary safety
information and access to this manual.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or duly qualified designated
persons in order to avoid a hazard.

D012222
Manual
Do not perform unauthorized repairs, disassembly or
assembly operations, add-ons, re-adjustments or
modification of the product beyond what is described in
this manual. Any use, modification or adjustment not
described in the most recent approved revision of the
manual is strictly forbidden. Do not perform service while the
product is connected to the mains power.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given adequate supervision or instruction
concerning the safe use of the appliance and they
understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall
not be performed by children without supervision.
Do not use the product if it has defects or signs of damage
are present. If the device makes unusual noise or smells,
switch off the mains voltage immediately.
Take care that the cables are not damaged. Unplug the
mains cable on mobile equipment before it is moved.
The products must only be used in an environment that
corresponds to their IP protection.
The information in this manual is based on correct
installation in accordance with installation instructions for
this product.
Korpinen cannot be held liable if the product is used in any
way that differs from stated in this manual and/or
installation instruction. Korpinen reserves the right to amend
this manual and reference documents without prior notice.

D012222
Manual
Product label symbols
This product is CE-marked in accordance with:
Council Directive 2006/42/EC on machinery
Council Directive 2011/65/EU, RoHS
Manufacturer name and address
Date of production
Stock number
Serial number
Consult manual before use
Operating interval of electrically operated equipment. The use of
electrical height adjustable equipment can run at maximum 2
minutes, followed by an 18-minute break.
Type B applied part. The product complies with IEC 60601-1
requirements to provide protection against electric shock.
Consult manual for important safety related information, warnings,
and safety precautions.
Class II, double isolated electrical components.
Do not dispose as unsorted municipal waste. Product must be
returned to a designated recycling station.
Mobile phones or other portable RF emitting equipment should be no
closer to the product than 30cm.
Operating and storing temperatures may not exceed 5-40°C

D012222
Manual
Exploded view
Figure 1. Exploded view
1 pc. 6202 Gaius
Original basin (sold
separate)
1 pc. 13982 Drain
pipe (sold
separate)
1 pc. Top cover
1 pc. Bottom cover
1 pc. Lift mechanism
1 pc. Operating
interface
1 pc. Faucet with 10
mm inlet tubing
(sold separate)

D012222
Manual
Figure 2. Reinforced area (Plywood 20 mm with full thread screws)

D012222
Manual
Water outlets
Drain area
Electrical outlet
230VAC IP44
Max dimensions:
Height 15 mm
80 x 80 mm or d80
IMPORTANT NOTICE! Floor drain should extend at least 235 mm from the floor. Tube
diameter 32 –40 mm. Tube center distance from wall 50-60 mm.

D012222
Manual
1. Install the basin support arms
Loosen the screws and
insert the support arms.
Make sure the support
arms are mounted as far
as they will go.
Install the operating
interface.

D012222
Manual

D012222
Manual
Install the three cable tie
mounts in these positions.

D012222
Manual
Loop the excess wire
around this cable tie
mount
The wire loop must be
greater than 140 mm.

D012222
Manual
2. Predrill all the neccesary holes and install the top screws
in the wall.
IMPORTANT NOTICE!
Please leave a 10mm gap
between the wall and the
screw head. Refer Fig. 3
for hole positions.
NOTICE! Fasteners sold
separate. Korpinen
product number 6219-Z.
Fastener type 8x60mm
Hexhead screw with
appropriate anchors.

D012222
Manual
3. Lift the basin lifter on top of the top screws in the wall.
Using a spirit level, ensure that the unit is installed level.
4. When the unit is level, tighten the top screws; insert and
tighten the bottom screws. Plug the lifter to mains power
and test the lifter before adhering the basin.
IMPORTANT NOTICE! While testing, keep hands
and tools away from the open mechanism.
Before continuing work, unplug the unit.

D012222
Manual
5. After testing the unit, adhere the basin to the frame
IMPORTANT NOTICE! Make
sure to leave a 5 –8 mm
gap between the basin
and any walls next to it
NOTICE! Basin sold
separate.

D012222
Manual
Figure 2. Cut 60 mm off the plumbing adapter.
6. Install the plumbing
NOTICE! Plumbing
hardware sold separate.
Korpinen product
numbers 13970 & 13982
IMPORTANT NOTICE!
Air lock must be
pressed and fixed to
the top position with
a cable tie. Flexible
drainpipe must be
held in place with a
hose clamp.
IMPORTANT NOTICE!
Cut the faucet tubes
to length. The faucet
tubes must be 10mm
in diameter
NOTICE! 13982 Flexible
drain pipe sold separate.
NOTICE! Do not forget
to move the air lock
O-ring to the rear
notch.

D012222
Manual

D012222
Manual
Figure 5. Floor drain layout
Figure 3. Wall drain installation (Mounting hardware
sold separate, Korpinen item no. 13983)
IMPORTANT
NOTICE! Hoses and
ball valves sold
separate (Korpinen
part no. 13970)
Figure 4. Water outlet connector must not protrude
more than 45mm from the wall. The connector must
point towards the floor

D012222
Manual
7. Install the bottom cover
IMPORTANT NOTICE!
Remember to tighten the
bottom screws

D012222
Manual
Using the supplied
cable ties and cable
tie mounts, mount the
excess power cord to
the specified area on
the bottom cover.
IMPORTANT NOTICE!
Do not tie the cables
outside of the
specified area