KRAM telecom Xpress mutecable 85 Series User manual

Xpress -mutecables
Made in Denmark by
Kram Telecom A/S
Xpress -mutecables
Instruction for
Xpress mutecable 85xxx
Pin
No.
Description Colour
1Speaker -Grey/Black
2Speaker -Grey/Black
3Mute Yellow
412v ignition Blue
5Speaker + Grey
6Speaker + Grey
712v permanent Red
8Earth Black
FWD Block
Warning!!!
CHECK the configuration
of the constant 12v and
the ignition wire as the
in some models can be
switch. If the wires is
switch it can be correc-
ted using the two bullit
connctors.
1
5
2
678
34
Diagram
Xpress mutecable 85xxx
The diagram shows the connector from the cable entry side
EN607

Product description
Xpress cable 85xxx
Xpress -mutecables are designed to interface between the
car radio and vehicle harness. It enables the use of one of the
car speakers when answering/making calls from your cell
phone.It also provides power supply for the handsfree kit and
mutes the radio in order to let the conversation be heard.
Normally no vehicle cables needs to be cut.
Speaker-function: This is achieved by connecting the carkit di-
rectly to one of the car speakers. By using the carkits built-in
relays, the telephone conversation is send through the car
speaker, while the radio is muted. This way you will achieve a
perfect hand free sound without interference from the car ra-
dio.
Power supply of the carkit: All Xpress mutecables are deliv-
ered with a power connector for the carkit, that way you
avoid cutting the cars wiring loom.
Note 1: This cableset is designed to plug directly into the FWD
Audio Profi and Audio 2000 carkits. Use of this Xpress mute-
cable with other carkits require a Carkit-specifik Xpress adap-
tor cable.
Note 2: The cableset is only to be used for cars without sepa-
rate amplifiers or active loudspeakers.
Xpress -mutecables Xpress -mutecables
Installation description
Xpress cable 85xxx
1st. Remove the radio/radio-unit from the car following the
manufacturers guide.
2nd. Disconnect the radio connector from the radio.
3rd. Connect the female end of the Xpress mutecable to the
cars wiring loom and connect the male end to the connector
at the back of the radio.
4rd. Check the configuration of the permanent plus and the
ignition power supply wires, as they in some vehicles can
be switched. The Ignition wire is the blue wire in the 8 way
FWD connector. And the permanent is the red wire.
5rd. Check the mute position. The mute position can varies
according to each model. and year of the vehicle, but it is
usually found at a prefitted position chosen by Kram Tele-
com. The mute wire is the yellow wire in the 8 way FWD
connector.
6rd. Connect the telephone to the carkit and check if the
carkit functions correctly
7rd. Refit the radio.
See our complete Xpress program on
www.kram.dk