Kramer VM-3H2 User manual

VM-3H2 Quick Start
P/N:
2900- 301131QS
Rev:
3
Scan for full manual
VM-3H2 Quick Start Guide
This guide helps you install and use your VM-3H2 for the first time.
Go to www.kramerav.com/downloads/VM-3H2 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-3H2 4K HDMI 2.0 1:3 DA
4 Rubber feet
1 Power supply (5V DC)
1 Quick start guide
Step 2: Mount VM-3H2
Install VM-3H2 using one of the following methods:
•Attach the rubber feet and place the unit on a flat surface.
•Fasten a bracket on each side of the unit and attach it to a flat surface
(see www.kramerav.com/downloads/VM-3H2).
•Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-3H2).
•Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the
device.
•Avoid uneven mechanical loading.
•Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of
the circuits.
•Reliable earthing of rack-mounted equipment should be maintained.
•Maximum mounting height for the device is 2 meters.
Step 3: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-3H2.
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-3H2.
Using third-party cables may cause damage!

Step 4: Connect power
Connect the power cord to VM-3H2 and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
•There are no operator serviceable parts inside the unit.
Warning:
•Use only the power cord that is supplied with the unit.
•Disconnect the power and unplug the unit from the wall before installing.
Step 5: Set DIP-switches
Set the DIP-switches according to your needs using the following table:
Programming mode
HDCP Input (MAC mode)
Force RGB
Lock Default EDID
DIP
1
2
3
4
OFF (up)
Normal mode
HDCP enabled
Force RGB
EDID not locked
ON (down)
Enable programming
HDCP disabled
Normal mode
EDID locked