Kremlin-Rexson airmix User manual

KREMLIN REXSON N° : 578.058.110-UK-1312
AIRMIX® AUTOMATIC SPRAY GUN
TROUBLESHOOTING GUIDE
TRANSLATION FROM THE ORIGINAL MANUAL
IMPORTANT : Before assembly and start-up, please read and clearly understand all the
documents relating to this equipment (professional use only).
THE PICTURES AND DRAWINGS ARE NON CONTRACTUAL. WE RESERVE THE RIGHT TO MAKE CHANGES WITHOUT
PRIOR NOTICE.
KREMLIN - REXSON
150, avenue de Stalingrad
93 245 - STAINS CEDEX – France
 : 33 (0)1 49 40 25 25 Fax : [phone]
www.kremlin-rexson.com

KREMLIN REXSON - 1 - N° : 578.058.110-UK-1312
TROUBLE CAUSE SOLUTION
No fluid out of the gun Tip is blocked
Shut off pressure on pump.
Depressurize the hoses.
Remove and clean spray tip and
filter.
Low flow rate Filter is partially clogged
Spray fan is not uniform
Tip is partially clogged
Spray fan is not uniform
Air holes in air cap are partially
blocked
Remove and clean with solvent.
Blow all air holes clear with
compressed air.
Excessive fluid fog Too much atomizing air Reduce atomizing air with the air
regulator.
Pattern width narrows during
reversing phase of pump
Air trapped in the fluid circuit Check connection and suction
hose quality.
Viscosity too high Reduce viscosity.
Air cap becomes dirtly frequently Too much air Reduce air pressure.
Seat-holder leaking Replace it.
Fluid seeping from the air holes
of the air cap Defective tip seal Replace it.
Retaining ring loose Tighten it.
Fluid leak through leakage
detector Cartridge worn Replace cartridge.
No change in pattern width Air leak in front of the gun Replace air adjuster.