KROHNE SHD 200 User manual

Quick Start
For initial set up, we strongly recommend the use of the relevant manuals in addition!
11/2019 – 4007946801 - QS SHD 200 R01 en 1
SHD 200
Control unit for 4…20 mA/HART® field devices
2 Electrical connection
Terminal designation Terminal assignments
J Loop2+
K Loop2-
FE Functional earth
S Shield
A1 Sensor+
B1 Sensor-
A2 HART+
B2 HART-
C Loop1+ (HART® resistor on board)
D Loop1+ (external HART® resistor)
E Loop1-
F Relay1+
G Relay1-
H Relay2+
I Relay2-
Installation, assembly, start-up and maintenance may only be performed by appropriately
trained personnel.
For use in hazardous areas, special codes and regulations are applicable which are supplied in
a separate document that describes all hazardous area relevant information.
The responsibility as to the suitability, intended use and corrosion resistance of the used
materials against the measured fluid of this device rests solely with the operator.
For complete documentation (manuals, supplementary manuals, data sheets and certificates)
please refer to www.krohne.com/Downloads.
1 Installation
1. Mark the holes with a suitable pen 1.
2. Drill the 4 holes and fasten the device securely to the wall 2
2
1

11/2019 – 4007946801 - QS SHD 200 R01 en 2
3 Quick Setup
Key Measuring mode Menu mode
Menu mode Sub-menu or
function mode
Parameter and
data level
> Switch from
measuring mode to
menu mode.
Access to main menu Access to submenu For numerical
values: move
cursor one position
to the right
 Reset of the
display
Return to
measuring mode (prompt
appears whether the data
should be saved)
Press 1 to 3 times,
return to menu
mode, data saved
Return to submenu
or function, data
saved
↑ or ↓ - Select menu Select sub-menu or
function
Use highlighted
cursor to change
number, unit,
property
Esc: > + ↑ - - Return to main
menu, data not
saved
Return to next sub-
menu or function,
data
not saved
Main menu Submenu
A Setup A1 Language
A2 Function mode
A3 HART settings A3.1 HART master
A3.2 Polling address range
A3.3 User specific address
A3.4 User specific range
A3.5 Manual hold
A3.6 Field device scan
A4 Display A4.1 1.Measurement page
A4.2 2.Measurement page
A4.3 3.Measurement page
Main menu Submenu
A4 Display A4.4 Trend graph
A4.5 Number format
A4.6 Illumination settings (settings depend on mode)
A4.7 Illumination settings (settings depend on mode)
A4.8 Contrast
A5 I/O A5.1 Loop 1 (settings depend on mode)
A5.2 Loop 1 (settings depend on mode)
A5.3 Loop 2
A5.4 Relay 1
A5.5 Relay 2
A6 Device A6.1 Information
A6.2 Security
B Test B1 System B1.1 PV
B1.2 SV
B1.3 TV
B1.4 QV
B2 Loop 2 B2.1 Current value
B3 Relay B3.1 Relay 1
B3.2 Relay 2
C Service This menu is password protected and contains functions to be used by
service personnel only.
Contact
To view all KROHNE locations and contact details visit:
www.krohne.com
Then “Select your country“ from the drop down list at the
top left of the page