KROHNE BATCHFLUX 3100 User manual

For initial set up, we strongly recommend the use of the relevant manuals in addition!
I
ns
t
a
ll
a
ti
on con
diti
ons
110 DN
25 DN
Adjustment after installation
A
- Do NOT remove the 4 spacer bushes B
1L
max
DN15 / ½" 2L
min
11/2020 - 4008533501 - BATCHFLUX 3100 R01 en 1 2
Check the device nameplate to ensure that
the device is delivered according to your
order
No turning or twisting of device
Quick Start
BATCHFLUX 3100 Installation
General installation requirements
Inlet, outlet and T-section
1
www.krohne.com/Downloads
Open feed / discharge
General
≥ 2 × ∅
1
2
XYZ (3D bends upstream) inlet length:
XY (2D bends upstream) inlet length:
Depends on
2D/3D bends
upstream
≥ 10 × ∅
≥ 5 × ∅
Transport
- No special requirements
- Use the original packing of the device(s)
when transporting to the installation location.
Device version(s)
Electromagnetic flowmeter for volumetric filling machines
Installation, assembly, start-up and maintenance may only be performed by appropriately trained
personnel.
For use in hazardous areas, special codes and regulations are applicable which are supplied in a separate
document that describes all hazardous area relevant information.
The responsibility as to the suitability, intended use and corrosion resistance of the used materials against
the measured fluid of this device rests solely with the operator.
For complete documentation (manuals, supplementary manuals, data sheets and certificates) please refer
to:
Device nameplate (example)
A = T ambient:
B = T proces:
-20…+60°C /-4…+140°F
-20…+45°C /-4…+113°F
Installation position
Avoid vibration / EM field
Lmax - Lmin < 0.5 mm / 0.02"
Do not use a rotation force on the device once mounted
between flanges.

Cable connector M12 - 5 pin
¯
+
1+24 VDC
2
3
4
5
11/2020 - 4008533501 - BATCHFLUX 3100 R01 en 3 4
Electrical connection2
Frequency output - (ground)
Frequency output +
Ground
3
Observe without fail the local occupational health and safety regulations.
Any work done on the electrical components of the measuring device may only be carried out by properly
trained specialists.
Then “Select your country“ from the drop-down list at the top left of
the page
The device must be grounded in accordance with regulations in order to protect personnel against electric
shocks.
All work on the electrical connections may only be carried out with the power disconnected.
Take note of the voltage data on the nameplate! Observe the national regulations for electrical
installations!
Contact
To view all KROHNE locations and contact details visit:
For the start up and menu description please refer to the applicable manual (e.g. BATCHMon
software/manual)
www.krohne.com
All the operating data are preset at the factory. For changing the parameters and
diagnostic purposes BATCHMon plus operation software can be used.
The frequency output is polarity sensitive. If connected incorrectly, the device will be damaged.
To be connected for servicing only
Refer to the manual for more details on connection options.
Grounding
Quick Setup