1. Set function knob to the proper AC A Range. Press the trigger to open the jaws and clamp on to one conductor only.
The transformer jaws pick up the AC current flowing through the conductor.
2. When only the figure "1" displayed, it indicates over range situation and the higher range has to be selected.
3. The reading will be indicated on the display.
5. OPERATING INSTRUCTION :
5.1 Measuring Current:
(1) Jaws should he completely closed while taking a reading.
(2) The most accurate reading will be obtained by the conductor across center of the transformer jaws.
NOTE:
5.2 AC Voltage Measurement :
1. Set the function knob to the AC V range.
2. Connect the black test lead to the "COM" terminal and red test lead to the "V/W" terminal. You can now place the test probes to the
source or load under measurement.
3. When only the figure "1" is displayed, it indicates over range situation disconnect the test leads immediately to avoid damage to
the meter.
5.3 DC Voltage Measurement :
1. Set the function knob to the DC V range.
2 Connect the black test lead to the "COM' terminal and red test lead to the "V/W" terminal. You can now place the test probes to the
source or load under measurement.
3. The polarity of red lead connection will be indicated along with the voltage value.
4. When only the figure "1" is displayed, it indicated over range situation disconnect the test leads immediately to avoid damage to
the meter
5.4 Resistance Measurement :
1. Set the function knob to the “ 20000W” range
2. Connect the black test lead to the “COM” terminal and red test lead to the V/W terminal.
3. Verify that the power to the circuit under test is off. Connect test lead to the circuit to make measurement.
NOTE: If the resistance being measurement exceeds, the maximum value of the range selected or the input is not connected,
an over range indication "1' will be displayed
WARNING
To avoid electrical shock, hazard or damage to the meter, do not attempt to measure voltage that might exceed DC 600V.
To avoid electrical shock, hazard or damage to the meter, do not attempt to measure voltage that might exceed AC 600V RMS.
(1) Attempting resistance or continuity measurements on live circuits can cause electrical shock, damage to the meter and damage
to the equipment under test.
(2) Resistance measurement must be made on de-energized circuit.
5.5 Continuity Test
1. Set the function knob to the “ 20000W” range.
2. Connect the black test lead to the "COM" terminal and red test lead to the "V/W" terminal.
3. Connect the test probes across two points of the circuit under testing. If continuity exists BUZZER will sound.
6. Maintenance :
Maintenance consists of periodic cleaning and battery replacement. The exterior of the meter can be cleaned with a dry clean cloth to
remove any oil, grease. Never use liquid solvents or abrasives
Replacing Battery :
When the meter displays the sign " ", the battery must be replaced to maintain proper operation. Remove the battery cover of case.
replace the exhausted battery with new one.
To avoid electrical chock, disconnect the test leads and any input signals before replacing the battery. Replace only with same type of battery.
WARNING
17, Bharat Industrial Estate, T. J . Road, Sewree (W), Mumbai - 400015. INDIA
Sales Direct: (022)24156638 Tel.:(022) 24124540, 24181649 Fax: (022) 24149659
®®
AN ISO 9001:2015 COMPANY
