KUSSMAUL 091-26 User manual

INSTRUCTION MANUAL
3 YEAR WARRANTY
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: [phone]
AUTO CHARGE 3
AUTOMATIC BATTERY CONDITIONER
INPUT: 120 VOLT, 50/60 Hz, 1 AMP MAX
MAX. OUTPUT: 12 VOLTS, 3 AMPS
NOTE:
THIS IS A CONDITIONER FOR MAINTAINING THE CHARGE IN A VEHICLE'S
BATTERY. IT WILL RECHARGE THE BATTERY SLOWLY BUT IS NOT RECOM-
MENDED FOR APPLICATIONS WITH AUXILIARY LOADS.
MODEL #091-26-12
BOOK# 091-26-12, 4-23-97

INTRODUCTION
The Auto Charge 3 Automatic Battery Charger is a compact, completely automaticcharger
designed for installation on vehicles with two batteries. An internal charge divider charges both
batteries simultaneously while maintaining complete battery isolation. A maximum output of 3
amperes privides sufficient current for vehicles which do not have large constant accessory
loads. Indicator lights are provided to signal when the charger is charging and when the
charging is complete.
Construction of the Auto Charge 3 is extremely rugged to withstand the shock and vibration
normally encountered by vehicle mounted equipment.The unit operates completely
automatically and stops charging the batteries when they are fully charged.There is no trickle
charge and therefore no danger of overcharging and water boiloff.Parasitic loads on the battery
such as a radio, lights, etc., up to a maximum of 2 amps are automatically supplied with current
fromthecharger.

INSTALLATION WIRING DIAGRAM
WIRE SIZE CHART
CONNECTION ITEM DEFINITION WIRE SIZE
COM
BATTERY
COMMON NEGATIVE CHARGING LEAD FOR BATTERIES 14 AWG
1
BATTERY
NO.1 POSITIVE CHARGING LEAD FOR BATTERY # 1 14 AWG
2
BATTERY
NO.2 POSITIVE CHARGING LEAD FOR BATTERY # 2 14 AWG
IMPORTANT: Wire size is for a
maximumlengthof40feet.Ifwiring
is to be longer, larger wiring is re-
quired. Additional information is
available on request.

SPECIFICATIONS
SPECIFICATIONS:
Input: 120 Volts, 60Hz, 1 amp
Output Volts: 13.25 volts nominal
Output Current: 0-3 Amps D.C. output current
determined by state of charge of batteries
Charge Indicator: RED LED indicates charging current
GREEN LED indicates fully charged
Remote Charge Indicator Connector: permits locating Red/Green LED's at
remote loaction
Weight: 6 lbs
OUTLINE DRAWING

INSTALLATION RECORD & WARRANTY
Date Installed
Installed By
Vehicle Identification
Vehicle Owner
WARRANTY
All product of Kussmaul Electronics Company Inc. are warranted to be free
of defects of material or workmanship. Liability is limited to repairing or
replacing at our factory, without charge, any material or defects which
become apparent in normal use within 3 years from the date the equipment
was shipped.
Kussmaul Electronics Company, Inc. shall have no liability for damages of
any kind to associated equipment arising from the installation and /or use of
the Kussmaul Electronics Company, Inc. products. The purchaser, by the
acceptance of the equipment, assumes all liability for any damages which
may result from its installation, use or misuse, by the purchaser, his or its
employees or others.