KUSSMAUL 091-7 User manual

INSTRUCTION MANUAL
3 YEAR WARRANTY
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796-1221
FILE: 091-7-xx.PM7.0
6/4/2004
TEL: in NY 631-567-0314631-567-0314
631-567-0314631-567-0314
631-567-0314 TOLL FREE: 800-346-0857800-346-0857
800-346-0857800-346-0857
800-346-0857 FAX: [phone]
631-567-5826631-567-5826
631-567-5826
NOTE :
This charger is designed for
vehicles with a single
battery system
INPUT : 115 volt, 50/60 Hz, .75 amp
MODEL #091-7-xx
MAINTENANCE MASTER
AUTOMATIC BATTERY CHARGER
1

1. INTRODUCTION
This procedure defines the installation and wiring for the 091-7-xx Maintenance Master Bat-
teryCharger.
2. MOUNTING
Mount the Maintenance Master Charger at some convenient location near the battery utilizing
two #8 x 1 screws provided. Mounting against a vertical wall is suggested, be certain that the
upper and lower surfaces of the charger are unobstructed to permit free circulation of air.
3. ELECTRICAL CONNECTIONS
Connect the charger output to the battery. Note that the output leads are marked “Pos” and
“Neg.”. Connect the lead marked “Pos” to the positive terminal of the battery and the lead
marked “Neg” to the negative terminal. This is easily accomplished with the #6 x 1/2 sheet
metal screws provided - these may be screwed directly into the battery cable. In those instal-
lationswherea connector is installed inthecharger output, the installer mustverifythe polarity
oftheconnector.
Note: USE ONLY A POLARIZED CONNECTOR.
2

CAUTION
DAMAGE TO THE CHARGER MAY OCCUR IF THE CHARGER LEADS
ARE CONNECTED TO THE IMPROPER TERMINALS OF THE BATTERY
VERIFY POLARITY BEFORE CONNECTING BATTERY
Upon completion of the charger output wiring, plug the charger into any convenient 115 volt,
50/60 Hz. outlet. Turn the power switch “ON”. The charger will charge the battery - as the
battery becomes fully chargedthe output current will decrease. Whenfullycharged the output
current will drop to zero.
4. CHARGER OUTPUT
The charger is calibrated to put out the voltage as follows:
Model Number Nominal Voltage Charger OutputVoltage
091-7-6 6 volts 6.70 +/- .05 volts
091-7-12 12 volts 13.25 +/- .1 volts
091-7-24 24 volts 26.50 +/- .1 volts
Output current is limited automatically so that when the engine is started or the battery is
deeply discharged, the charger protects itself.
3

INSTALLATION WIRING
4

INSTALLATION RECORD & WARRANTY
Date Installed
Installed By
Vehicle Identification
Vehicle Owner
WARRANTY
All products of Kussmaul Electronics Company Inc. are warranted to
be free of defects of material or workmanship.Liability is limited to repairing
or replacing at our factory, without charge, any material or defects which
become apparent in normal use within 3 years from the date the equipment
was shipped. Equipment is to be returned, shipping charges prepaid and
will be returned, after repair, shipping charges paid.
Kussmaul Electronics Company, Inc.shall have no liability for damages
of any kind to associated equipment arising from the installation and /or use
of the Kussmaul Electronics Company, Inc.products.The purchaser, by the
acceptance of the equipment, assumes all liability for any damages which
may result from its installation, use or misuse, by the purchaser, his or its
employees or others.
5