Kyocera FS-1100 User manual

© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninetimaging.com
KYOCERA®FS-1100
EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS
KYOCERA FS-1100 TONER CARTRIDGE

1. Drill a 1/2” to 3/4” hole into the fill plug. The OEM plugs are
welded in so the hole is necessary. Clean out all the remaining
toner.
KYOCERA FS-1100 EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninetimaging.com
The Kyocera FS-1100 cartridges are rated for 4,000 pages. The OEM part number is TK-142.
There is a chip used on this cartridge that must be replaced each cycle.
The chips are regional, so make sure you have the correct one!
REMANUFACTURING THE
KYOCERA FS-1100 TONER CARTRIDGE
By Mike Josiah and the Technical Staff at UniNet

2. Make sure the toner port is closed.
Fill the cartridge with toner for use in the TK-142 series of cartridges.
Use a Samsung CLP-300 seal to cover the hole you drilled.
3. If shipping the cartridge, place a small strip of tape across
the toner port.
KYOCERA FS-1100 EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninetimaging.com

4. Peel off the old chip label (it is an RF type chip).
Install the new chip label.
KYOCERA FS-1100 EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.uninetimaging.com