Setting of the ears
Setting of the batteries
Insert the ear into the opening as shown in the
photo below.
Ensure to orient the ear so that the sliding guides
on the ear unit and the wall of the opening
match together.
To detach the ear, please grasp gently around
the base of the pinna and pull straight out,
perpendicularly to the head.
4
Preparation
Please
note
Preparation
4
The battery box is at the back of the shoulder unit.
With pushing the tab at the right side of the lid to the left, pull it to open the lid.
Set two size AA batteries in the box. Ensure the direction of the batteries. The position of
positive or negative electrodes is indicated in the box.
After setting the batteries, close the lid as the following procedure. Put the two small tabs at the
left side of the lid to the indents at the left side of the battery box then push the lid to close.
Turn on the power switch when the training session begins.
Please note: Do not mix-up the different types of ears for different trainings:
Examination with an otoscope: Use "Exam Ear"s (mark 1 or 2).
Foreign body removal: Use "FB Ear"s (mark 3 or 4).
After inserting the ears, turn on power.
In case the ears are inserted while the system is powered, sensors may work and generate
the alarm sound. When alarm won't not stop, turn off the power and then turn it back on.
To ensure the procedure of attachment and detachment of the ear, refer to the movie before
using the model. The movie address is as follow and you can find the movie with the right QR
code.
（ https://youtu.be/2G4MPw1V9qI ）
•Continuous sound --- Turn off the power and then turn on.
•Intermittent tone --- It is necessary to adjust the position of the ears. Insert your finger into
ear canal and push the ear in more deeply.
