Lafayette Manh Truc User manual

Installation Instructions
Panel Drape
Tools Needed
Power Drill, 1/4”Driver and drill bits
Tape Measure
Flat blade Screwdriver
Phillips Screwdriver
Pencil
Level
Mounting Surface Fastener
Wood
Drywall, Plaster
Metal
#6 Hex Head
Provided
Wall Anchors
Not Provided
Sheet Metal
Not Provided
Parts List
Screws: 1 1/2” into wall
3/4” into headrail
3” for 1” projection
Cord Cleat: 1 per standard shade
2 per TD/BU shade
Up to 48 1/4”
48 3/16” - 60 1/16”
60 1/4” - 72 1/16”
72 1/4” - 84 1/16
84 1/4” - 96 1/16”
96 1/4” - 108 1/16”
108 1/4” - 120”
Panel Width Brackets Required
5
6
7
8
9
10
11
Thank you for choosing Lafayette’s Panel Drape. With proper installation and
care, your new panel drape will provide many years of beauty and performance.
BEFORE INSTALLING
- Remove shade from the package. Keep all packaging
until the shade operates to your satisfaction. Contents
of your hardware package may vary depending on
options chosen. Additional fasteners may be needed
based on your specic mounting surface.
INSTALL THE BRACKETS
Wall Bracket
- The center of the end brackets should be marked on
the mounting surface 2” in from the ends of the
headrail. Space remaining brackets evenly between
the end brackets. Adjust placement to avoid any
obstructions that may occur.
- Center a bracket over a mark on the mounting
surface and making sure bracket is level and aligned,
attach the bracket using the screws provided. Repeat
the process for the rest of the brackets.
Ceiling Bracket - White and Brown
- Center a bracket over a mark on the mounting
surface and drill a screw up through the hole in the
bracket. DO NOT tighten the screw. Repeat the
previous steps for the remaining brackets.
.
Space Evenly Space Evenly
2” 2”
Ceiling
Screw In
Do Not Tighten
White Bracket
Ceiling
Screw In
Do Not Tighten Brown Bracket

Manh Truc Panel Drape Installation Instructions 2
INSTALL THE DRAPERY ROD
Wall Bracket
- Taking the drapery rod, insert the back edge of the
rod into the mounting bracket.
- Push up on the drapery rod to snap it in the front and
tighten each screw on the bracket to hold the rod
securely in place.
Ceiling Bracket - White
- Insert the back edge of the drapery rod into the
bracket and push back.
- Push up on the front of the drapery rod. (If done
correctly, you should hear the rod snap into the
bracket) and tighten the screw on all brackets.
Ceiling Bracket - Brown
- Install the drapery rod by sliding the end of the rod
through the brackets until each bracket is holding the
rod. Make sure the rod is positioned correctly and
tighten the screw on all brackets.
Push Back
Ceiling
Ceiling
Push Up
Push Back
Push Up
Tighten
Ceiling
Slide through each bracket
Tighten
INSTALL THE PANEL DRAPE
Wall Bracket
- First make sure the end caps are not inserted into the
ends of the drapery rod.
- Making sure that the front of the panel drape is
showing, start to insert each of the carriers into the
end of the drapery rod.
- For the end that has to be stationary, insert a screw
stopper into the correct end of the drapery rod
before you insert the nal carrier.
- After inserting the nal carrier, insert an end cap on
the stationary side and tighten it with a screwdriver.
- Tighten the screw stopper making sure the carrier is
right in between the screw stopper and the end cap
screw. Note: If the drapery rod will not t in all the
brackets, make sure all of the brackets are level and
aligned. Also make sure that the screws are loose
enough on the bracket for the rod.
18-5704-00 September 2015
CARE AND CLEANING
- Light dusting is recommended for Manh Truc fabrics.
Because the Manh Truc materials are “natural” and
include grasses, reeds and bamboos cleaning with
water or any detergent is NOT recommended. Dusting
with a vacuum attachment can be done with extreme
care on low suction. The lining materials for Manh Truc
can be spot cleaned using warm water and detergent.
Do NOT immerse the lining in water.