Lafayette PARKE Faux Wood Shutters User manual

Installation Instructions
L-Frame and Z-Frame
Faux Wood Shutters
Before Installing
Tools Fasteners
Carefully unwrap your frames. Your frames will be labeled Left Top and Right Top, Top and Bottom.
Additional fasteners may be needed on your specic mounting surface.
Pencil Screw
Driver Level Measuring tape Drill 2 1/2” - 3” Wood Screw
(not provided)
Thank You
Thank you for choosing Parke Faux Wood
Shutters.
With proper installation and care, your
new shutters will provide many years of
beauty and performance.
Step 1 Prep Frame
Lay out your frame to begin building it
Line up rout on frame piece with
Hoffman key and press rmly until
seated to build frame
Pre-drill holes 2” down from the top of the Side pieces
Pre-drill holes 2” in from each side on the Bottom Piece
2”
2 ”
2”
2 ”
Inside Mount Outside Mount

Installation Instructions
Faux Wood Shutters
Step 2
Step 3
Install Frame
Install Shutter Panel(s)
Secure frame to window opening using the top two screws only
Additional screws may be needed along the sides depending on the size of
your window size
Inside Mount Outside Mount
Line up your hinges on your panel with
the hinges on the frame
With panel in place, insert the hinge
pins provided
Close panel and inspect gaps on top
and bottom
If installing the Shutter in an inside mount location, shims (not
provided) may be required to accomodate an uneven surface

Installation Instructions
Faux Wood Shutters
Step 4
Step 5
Check for Squareness
Secure Bottom of Frame
If either gap on top or bottom of the
Shutter Panel is uneven, your frame
may need adjusted
With all of the gaps even, secure
the bottom of the frame with screws
through the pre-drilled holes
Shift bottom of Frame left and right
until the gap is even on top and bottom
Mark position and hold in place
NO-NUM-BER AUG. 2019