LaGard LGBASIC 3710 Operation instructions

(P/N) 754.118 Rev B 02/12 • © copyright 2006-2012 Kaba Mas LLC
Page 1 of 2
OPENING THE LOCK
1. Enter valid six (6) digit combination. (Factory set to 1-2-3-4-5-6)
2. The lock will confirm a valid combination entry with a double signal.
3. Within four (4) seconds, turn handle to the open position.
4. Pull door open.
• Invalid Combination Entry - Lock will signal three (3) times.
WRONG TRY PENALTY
• Entry of four (4) consecutive invalid combinations starts a ve (5) minute
delay period.
- LED flashes red at ten (10) second intervals.
• At the end of the delay period, two more consecutive invalid combinations will
restart an additional five (5) minute delay period.
NOTE: Entry will not respond to keystrokes during delay period.
CHANGING YOUR COMBINATION
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
1. Enter “zero” six times.
2. Enter your existing six (6) digit combination one time.
3. Enter your NEW six (6) digit combination two times.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
5. Test lock operation several times before closing the door.
CAUTION: When selecting a combination do not use birthday or other predictable
data that could give correlation between the user and combination. Keep the
combination secret.
USER OPERATING INSTRUCTIONS
3710
Electronic Entry Device
FEATURES
See Manager Instructions for additional features.
USER Combination
• Open Lock
• Change Combination
WRONG TRY PENALTY
• Four (4) consecutive invalid combination initiates
five (5) minute delay period.
LOW BATTERY WARNING
• Repeated LED ashing and beeping during
opening indicates battery is low and needs
immediate replacement.
AUDIO AND VISUAL SIGNAL
• Double signal - two (2) LED ashes and two (2)
beeps - indicates entry is valid or accepted.
• Triple signal - three (3) LED ashes and three (3)
beeps - indicates invalid or not accepted.

(P/N) 754.118 Rev B 02/12 • © copyright 2006-2012 Kaba Mas LLC
Page 2 of 2
• Valid Combination Entry - Double signal after valid six (6) digit combination
is entered.
• Invalid Combination Entry - Triple signal indicates old combination is still valid.
BATTERY LOW WARNING
• Repeated LED ashing and beeping during an opening indicates that the battery
is low and needs immediate replacement.
• Uses one (1) 9-Volt alkaline battery only. (Example: Duracell™ or Eveready™
alkaline batteries.) It is recommended that batteries be replaced at least once
a year.
If battery is depleted and will not allow lock to open, follow instructions below.
Lock contains a non-volatile memory; even with the batteries removed the lock
will retain all programming.
CHANGING YOUR BATTERY
1. Remove black plastic battery compartment
cover (located at the bottom of the keypad)
by gently pulling downward on its handle.
2. Allow the battery and its attached leads to
drop down and out of the battery
compartment. If it does not drop, gently pull
on the battery until it does.
3. Remove the connector by unsnapping
it from the two terminals on the top of
the battery.
CAUTION! Hold onto battery terminal
connector to avoid pulling the wires out of
housing.
4. Press and hold the zero(0) key for ten (10)
seconds before installing a new battery.
5. Connect a new 9-Volt alkaline battery to the
battery clip.
6. Push the battery and the leads completely
into the battery compartment.
7. Install the battery cover by placing one side
of the cover in position and then pressing
the other side into position with your finger.
Mounting Instructions available at www.kaba-mas.com.