Lake Shore Giant Sand & Water Table User manual

Assembling your sand & water table is quite easy. Just follow the
written instructions and accompanying illustrations—you’ll be done in
no time! To assemble your table, you will need a wrench and a Phillips
screwdriver. All other hardware is included.
What’s Included
• Sand & water tub • 2 braces
• 8 bolts • 8 nylock nuts
• 2 side frames (with adjustable legs) • 8 washers
Assembly Instructions
©2009 Lakeshore LA308/LA309
[phone] Ages 3+
www.lakeshorelearning.com Printed in China and U.S.A.
Giant/Economy
Sand & Water Tables
1Use the bolts to attach the side frames to the braces. Place a
washer on each bolt, between the frame and the brace. Be sure
to insert the bolts so that their heads are on the outside of the
frames. Attach the cap nuts to the bolts. Tighten with the wrench
and screwdriver.
(continued on back)

Adjusting the
Table Legs
The economy table has legs
that can be adjusted to two
heights, while the giant table
can be adjusted to three
different heights.
To adjust the legs to the
desired height, simply push in
the tabs and slide the legs up
or down, as shown at right.
Be sure to adjust the legs
before you place anything in
the tub!
2Drop the sand & water tub into the frame. Your new sand &
water table is ready to use! Enjoy!