LeapFrog Leap Builders 123 Fix-It Truck Assembly Instructions

91-003554-002 US
Parent’s Guide
This guide contains important information. Please keep it for future reference.
TM

2
INTRODUCTION
Thank you for purchasing the LeapBuilders®123 Fix-It Truck™.
This interactive truck building set comes with a Smart Star™
cube, fifteen special blocks and fifteen double-sided learning
blocks. Insert the learning blocks into the interactive Smart StarTM
cube to learn about objects, numbers and colors. Inspire open-
ended creativity and stacking fun with all the blocks.
On/Off/Volume
Control Switch
Music Button Question
Button
Smart StarTM
Cube

3
INCLUDED IN THIS PACKAGE
• One Smart Star™ cube
• 15 truck blocks

4
• 15 double-sided learning blocks
Front
Back
Front
Back

5
Front
Back
• One parent’s guide
• One assembling guide
WARNING:
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE:
Please keep this parent's guide as it contains important
information.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes et vis d’emballage. Ils ne font
pas partie du jouet.
Note :
Il est conseillé de conserver ce guide des parents car il
comporte des informations importantes.

6
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use a screwdriver
to loosen the screw.
3. Install 2 new AAA batteries
following the diagram inside the
battery box. (The use of new
alkaline batteries is recommended
for maximum performance).
4. Replace the battery cover and tighten the screw to secure.
Unlock the packaging lock:
Rotate the packaging lock 90 degrees
counterclockwise.
1
2Pull out the packaging lock and discard.

7
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
MISE EN GARDE
• Utiliser des piles alcalines neuves pour des performances
maximales.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mélanger différents types de piles ou d’accumulateurs,
ne pas mélanger des piles ou des accumulateurs neufs avec
des usagés.
• Ne pas utiliser des piles ou des accumulateurs endommagés.
• Mettre en place les piles ou les accumulateurs en respectant
les polarités + et –.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur
en court-circuit (en reliant directement le + et le –).
• Enlever les piles ou les accumulateurs usagés du jouet.
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Ne les jeter ni au feu ni dans la nature.
• Ne pas tenter de recharger des piles non rechargeables.
• Enlever les accumulateurs du jouet pour les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.

8
PRODUCT FEATURES
1. On/Off/Volume Control Switch
To turn the unit ON, slide the On/
Off/Volume Control Switch to
the Low Volume () or High
Volume() position. To turn the
unit OFF, slide the On/Off/Volume
Control Switch to the OFF( )
position.
2. Automatic Shut Off
To preserve battery life, the 123 Fix-It Truck™ will automatically
shut off after approximately 90 seconds without input. The
unit can be turned on again by pressing any button or by
inserting a block into the interactive Smart Star™ Cube.
NOTE: This product is in try-me mode in the packaging. After
opening the package, turn the product off and on again
to proceed with normal play. If the unit powers down
while playing, try installing a new set of batteries.
3. Music Button
Press the Music Button to hear
short tunes and sing-along songs
about numbers and tools. The lights
will flash with the sounds.
4. Learning Button
Press the Learning Button to hear
playful phrases and short tunes
while playing. The lights will flash
with the sounds.

9
5. Smart Star™ Cube
Insert the Double-Sided Learning
Blocks into the interactive Smart
Star™ Cube to learn about tools,
numbers and colors. The lights will
flash with the sounds.
6. Stacking Fun
Stack the blocks onto the main unit
to hear fun sound effects.
7. Mix and Match
For added fun, the 123 Fix-It Truck™ interacts with the blocks
from other LeapBuilders®playsets. Simply put a block from
another LeapBuilders®playset into the interactive Smart
Star™ Cube to see flashing lights, hear learning phrases and
short tunes (additional playsets sold separately).
SING-ALONG SONG LYRICS
Song 1
I’m just a truck.
I like to move lots of stuff.
And I have a crane,
To help me lift the blocks way up high.
I put out the cones.
Remember safety first.
These are just a few of the things that you can do when you’re
a truck!

10
Song 2
One, two, three,
Four, five, six,
Seven, eight, nine, and ten.
Put the number blocks up in the truck.
And then we’re gonna count again. Let’s go!
Song 3
When you’re a truck
All the tools are your best friends.
Hammers and nails,
Wheelbarrow and a bucket.
Pliers and chains,
Just be sure to wear your hard hat.
What shall we build together today?
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp
cloth.
2. Keep the unit out of direct sunlight and away from any
direct heat source.
3. Remove the batteries when the unit will not be in use for
an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the
batteries.