LeapFrog LeapBuilders 123 Counting Train Assembly Instructions

91-003640-005 US
Parent’s Guide
This guide contains important information. Please keep it for future reference.
123 Counting TrainTM

2
INTRODUCTION
Thank you for purchasing the LeapBuilders® 123 Counting Train™
set.
This interactive train building set comes with 10 double-sided
learning blocks and nine building pieces, including an electronic
Smart Star™ cube. Insert the learning blocks into the interactive
Smart Star™ cube to learn about occupations, colors and
numbers. Inspire open-ended creativity and stacking fun with
all the pieces.
Music
Button
Question
Button
On/Off/Volume
Control Switch
Smart StarTM
Cube

3
INCLUDED IN THIS PACKAGE
• One Interactive Smart Star™Cube
• Eight Non-Electronic Building Pieces

4
• 10 Double-Sided Learning Blocks
Front
Back
Front
Back
• One booklet of building ideas
• One parent's guide

5
Rotate the packaging lock 90 degrees
counterclockwise.
1
2Pull out the packaging lock and discard.
Unlock the packaging locks:
WARNING:
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cord and packaging screws
are not part of this toy, and should be discarded for your child’s
safety.
NOTE:
Please keep this parent's guide as it contains important
information.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes et vis d’emballage. Ils ne font
pas partie du jouet.
NOTE :
Il est conseillé de conserver ce guide des parents car il comporte
des informations importantes.

6
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use screwdriver
to loosen the screw.
3. Install 2 new AAA batteries
following the diagram inside the
battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.

7
MISE EN GARDE
• Utiliser des piles alcalines neuves pour des performances
maximales.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mélanger différents types de piles ou d’accumulateurs,
ne pas mélanger des piles ou des accumulateurs neufs avec
des usagés.
• Ne pas utiliser des piles ou des accumulateurs endommagés.
• Mettre en place les piles ou les accumulateurs en respectant
les polarités + et –.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur
en court-circuit (en reliant directement le + et le –).
• Enlever les piles ou les accumulateurs usagés du jouet.
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Ne les jeter ni au feu ni dans la nature.
• Ne pas tenter de recharger des piles non rechargeables.
• Enlever les accumulateurs du jouet pour les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
PRODUCT FEATURES
1. On/Off/Volume Control Switch
To turn the unit On, slide the
On/Off/Volume Control Switch
to the Low Volume or High
Volume position. To turn
the unit Off, slide the On/Off/
Volume Control Switch to the
Off position.

8
2. Automatic Shut Off
To preserve battery life, the LeapBuilders® 123 Counting
Train™ set will automatically shut off after approximately 90
seconds without input. The unit can be turned on again by
pressing any button or by inserting a Learning Block into
the interactive Smart Star™Cube.
NOTE: This product is in Try-Me mode in the packaging. After
opening the package, turn the product off and on again
to proceed with normal play. If the unit powers down
while playing, please install a new set of batteries.
ACTIVITIES
1. Music Button
Press the Music Button to hear
short tunes and sing-along songs
about occupations. The lights will
flash with the sounds.
2. Question Button
Press the Question Button to hear
interactive questions and short
tunes. The lights will flash with the
sounds.

9
3. Smart Star™ Cube
Insert the double-sided Learning
Blocks into the interactive Smart
Star™ Cube to learn about colors,
numbers and occupations. The
lights will flash with the sounds.
4. Stacking Fun
Stack the blocks onto the electronic
Smart Star™ Cube to hear fun
sound effects, phrases and short
tunes.
5. Mix and Match
For added fun, the LeapBuilders®123 Counting Train™ set
interacts with the Learning Blocks from other LeapBuilders®
sets. Simply put a Learning Block from another LeapBuilders®
set into the interactive Smart Star™ Cube to see flashing
lights and hear learning phrases and short tunes (additional
sets sold separately). Please note, blocks from sets in
different languages have unique audio responses and cannot
be used interchangeably.
SING-ALONG SONG LYRICS
Song 1
All aboard!
Let’s learn about the things that you can do,
When you grow up! Yeah!

10
Song 2
The sun is up, we’re off to work.
Climb aboard the train, and we’ll get you to your destination.
Song 3
Whistles blowing,
The Colors Express is going.
Everywhere we look, colors up and down the track.
Towards the rainbow, the sun is shining on our back.
All aboard!
Song 4
Learning can be lots of fun,
With LeapBuilders.
Learning blocks for everyone,
Learning with LeapBuilders now. Yeah!
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp
cloth.
2. Keep the unit out of direct sunlight and away from any
direct heat source.
3. Remove the batteries when the unit will not be in use for
an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to moisture or water.