LeapFrog Letter-Go-Round 6143 User manual

Instruction Manual
This manual contains important information. Please keep it for future reference.
Letter-Go-Round
Letter-Go-RoundLetter-Go-RoundLetter-Go-Round

2
INTRODUCTION
Thank you for purchasing the Letter-Go-Round™!
Learning colors, counting, letters and animal sounds has never
been more fun! Tap the drum to count 1-10 and learn about
colors, or spin around the letter wheel to learn about animals
from A to Z. Sit, spin, play and learn!
On/Off/Volume
Selector
Color LED Drum
Letter Wheel
Mode Selector
Spinner Base

3
INCLUDED IN THE PACKAGE
• Letter-Go-Round™
• Quick Start Guide
Electronic panel Spinner Base
Supporting pillar
Panel
components A
Panel
components B
ASSEMBLY
1. Place both Panel
Components A
to Spinner Base,
letter side up.
2. Attach the two
Panel Components
A to the Spinner
Base, using five
screws per panel.
20 screws

4
5. Attach the Supporting Pillar to the
Electronic Panel. You will hear a snap
when the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
6. Attach the Supporting Pillar to the
Spinner Base. You will hear a snap when
the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
3. Place both Panel
Components B next
to the Spinner Base,
letter side up.
4. Attach the two
Panel Components
B to the Spinner
Base, using five
screws per panel.
Suitable for children up to Maximum load 55 lb (25 kg).
Convient aux enfants jusqu’à 25 kg maximum.

5
Unlock the Packaging Locks
Rotate the packaging locks 90
degrees counterclockwise.
Pull out the packaging locks.
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy, and should be discarded for your child’s
safety.
NOTE
Please save this Instruction Manual as it contains important
information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes, cordons et vis d’emballage. Ils
ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il
comporte des informations importantes.
CAUTION:
ADULT ASSEMBLY REQUIRED.
This package contains small parts.
For your child’s safety, do not let your child
play with the toy until it is fully assembled.
ATTENTION :
CE JOUET DOIT ÊTRE ASSEMBLÉ PAR UN ADULTE.
Ce jouet contient des petits éléments.
Pour la sécurité de votre enfant, ne pas le laisser
jouer avec le jouet tant que ce dernier n’est pas
complètement assemblé par un adulte.

6
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw and then open the battery
cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.

7
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in
fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
NOTE
This product is in Try-Me mode in the packaging. To activate
normal play mode, please switch the On/Off/Volume Selector
to Off and then back to On to activate normal play mode.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION:
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

8
PRODUCT FEATURES
1. On/Off/Volume Selector
Slide the On/Off/Volume Selector to turn
the toy on and select the volume.
2. Letter Wheel
Sit on the Spinner Base and spin around
the Letter Wheel while exploring 26
letters and animals.
3. Color LED Drum
Tap the light-up color LED Drum button
to hear learning phrases in different
modes.
4. Mode Selector
Move the Mode Selector to play in Letter
mode, Colors & Counting mode, and
Animal mode.

9
ACTIVITIES
Letter Mode
Sit on the Spinner Base and spin around
the Letter Wheel and tap the Drum to hear
letters and letter sounds.
Colors & Counting Mode
Sit on the Spinner Base and spin around the
Letter Wheel to play a color game and tap
the Drum to count from 1 to 10.
Animal Mode
Sit on the Spinner Base and spin around
the Letter Wheel and tap the Drum to hear
animal names and animal sounds.
Song Lyrics:
Letter Song
Here we go round the alphabet, alphabet, alphabet.
Here we go round the alphabet from A to Z.
Animal Song
Animals, animals all around
Spin, spin yourself around and around.
Color Song
Red light, green light, give the wheel a spin!
Don’t stop, don’t stop, spin around again!
Let’s go!

10
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the
unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions,
please follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a new set of batteries.

11
Environmental phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power OFF and back ON, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
Impact de l’environnement
Une défaillance de fonctionnement de l’appareil peut
survenir s’il est sujet à des interférences avec les fréquences
radioélectriques. Le fonctionnement normal de l’appareil devrait
reprendre avec l’arrêt des interférences. Si ce n’est pas le cas, il
peut s’avérer nécessaire d’éteindre et rallumer l’appareil ou de
retirer et réinstaller les piles. Dans l’éventualité peu probable
d’une décharge électrostatique, un mauvais fonctionnement
et une perte de mémoire de l’appareil peuvent se produire.
L’utilisateur doit alors retirer et réinstaller les piles pour
réinitialiser l’appareil.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-701-5327 in the U.S. and Canada, or email
[e-mail]. Creating and developing LeapFrog
products is accompanied by a responsibility that we take very
seriously. We make every effort to ensure the accuracy of the
information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that
we stand behind our products and encourage you to contact
us with any problems and/or suggestions you might have. A
service representative will be happy to help you.

12
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.

13
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: LeapFrog®
Model: 6143
Product Name: Letter-Go-Round™
Responsible Party: LeapFrog Enterprises, Inc.
Address: 2200 Powell Street, Suite 500
Emeryville, CA 94608
Website: leapfrog.com

Visit our website for more
information about our products,
downloads, resources and more.
leapfrog.com
leapfrog.ca
Read our complete warranty policy online at
leapfrog.com/legal
LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2021 LeapFrog Enterprises, Inc.
All rights reserved.
Printed in China.
IM-614300-000
Version:0