LeapFrog Letter-Go-Round User manual

Instruction Manual
This manual contains important information. Please keep it for future reference.
Letter-Go-Round
Letter-Go-RoundLetter-Go-RoundLetter-Go-Round

2
INTRODUCTION
Thank you for purchasing the Letter-Go-Round™!
Learning colours, counting, letters and animal sounds has never
been more fun! Tap the drum to count from 1-10 and learn about
colours, or spin around the letter wheel to learn about animals
from A to Z. Sit, spin, play and learn!
On/Off/Volume
Selector
Colours LED Drum
Letter Wheel
Mode Selector
Spinner Base

3
INCLUDED IN THE PACKAGE
• Letter-Go-Round™
• Quick Start Guide
Electronic panel Spinner Base
Supporting pillar
Panel
components A
Panel
components B
ASSEMBLY
1. Place both Panel
Components A
to Spinner Base,
letter side up.
2. Attach the two
Panel Components
A to the Spinner
Base, using five
screws per panel.
20 screws

4
5. Attach the Supporting Pillar to the
Electronic Panel. You will hear a snap
when the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
6. Attach the Supporting Pillar to the
Spinner Base. You will hear a snap when
the pieces are properly connected.
These pieces cannot be taken apart
after assembly.
3. Place both Panel
Components B next
to the Spinner Base,
letter side up.
4. Attach the two
Panel Components
B to the Spinner
Base, using five
screws per panel.
Suitable for children up to 55 lbs./25 kg.

5
Unlock the Packaging Locks
Rotate the packaging locks 90
degrees anticlockwise.
Pull out the packaging locks.
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy, and should be discarded for your child’s
safety.
NOTE
Please save this Instruction Manual as it contains important
information.
CAUTION:
This package contains small screws.
ADULT ASSEMBLY REQUIRED.
For your child’s safety, do not let your child
play with the toy until it is fully assembled.

6
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw.
3. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery.
4. Install 2 new ‘AA’ (AM-3/LR6) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

7
Disposal of batteries and product
The crossed-out wheelie bin symbols on products
and batteries, or on their respective packaging,
indicates they must not be disposed of in domestic
waste as they contain substances that can be
damaging to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or
lead (Pb) set out in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed
on the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
LeapFrog®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points
near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

8
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in
fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

9
PRODUCT FEATURES
1. On/Off/Volume Selector
Slide the On/Off/Volume Selector to turn
the toy on and select the volume.
2. Letter Wheel
Sit on the Spinner Base and spin around
the Letter Wheel while exploring 26
letters and animals.
3. Colour LED Drum
Tap the light-up colour LED Drum button
to hear learning phrases in different
modes.
4. Mode Selector
Move the Mode Selector to play in Letter
mode, Colours & Counting mode, and
Animal mode.

10
ACTIVITIES
Letter Mode
Sit on the Spinner Base and spin around
the Letter Wheel and tap the Drum to hear
letters and letter sounds.
Colours & Counting Mode
Sit on the Spinner Base and spin around the
Letter Wheel to play a colour game and tap
the Drum to count from 1 to 10.
Animal Mode
Sit on the Spinner Base and spin around
the Letter Wheel and tap the Drum to hear
animal names and animal sounds.
Song Lyrics:
Letter Song
Here we go round the alphabet, alphabet, alphabet.
Here we go round the alphabet from A to Z.
Animal Song
Animals, animals all around
Spin, spin yourself around and around
Colour Song
Red light, green light, give the wheel a spin!
Don’t stop, don’t stop, spin around again!
Let’s go!