LEGRAND RCFREMOTE User manual

Inspire Remote Control Kit
Cat.No: RCFREMOTE
Instruction Manual
1
PLEASE READ ALL INSTRUCTIONS CAREFULLY. RETAIN FOR FUTURE REFERENCE.
Product Specifications
Supply Voltage: 230-240V ~ 50 Hz
Standby: <0.5 W
Output Rating Fan Motor: 50 W
Output Rating LED Light: 15 W
Light Dimmer: Non-dimmable
1. Remote control kit is adaptable with hangsure brackets for ceiling fans.
2. The remote control cannot be used in combination with a wall mounted fan controller.
3. Fan can be directly connected using the cable connector (provided) on the remote control kit.
4. If the fan model has lights, you can use both the remote and wall control to switch ON/OFF the lights.
5. The remote and the receiver have already been paired during manufacturing.
IMPORTANT CONSIDERATIONS1
■Remote control
■Remote receiver
■Remote mounting bracket
■2 x Screws and lugs for bracket
■Instruction manual
■Loom
Box Contents
ON/OFF
2H
HI
MED
LOW
OFF
4H
8H
2 INSERTING THE RECEIVER AND CONNECT THE QUICK CONNECTOR
STEP 1
Unplug the Inspire fan quick connector
from the terminal block.
Insert the receiver into the gap between
hanger ball and bracket.
Receiver Receiver
While installing a remote control, it must be installed in conjunction with wall plate.
Hangsure Canopy
Tighten with 4 screws to the bracket. Make sure wires
are not trapped in between.
The receiver antenna can be left inside the metal canopy.
STEP 3
STEP 2
Receiver Antenna
N
L
x 2 Screws
x 2 Screws
To connect receiver to FAN with Light To connect receiver to FAN without Light
3 WALL ISOLATOR AND REMOTE COMPATIBILITY
Must replace 3 speed controller
with a wall switch.
Must connect existing motor active
wire to the new wall plate.
(Must remove these wall plates
if installing RCF Inspire remote)
(This wall plate is not
supplied with this kit)
3 way from the
terminal block
4 Way from the
terminal block
4 Way
4 Way
3 Way
3 Way
TO FAN
3 Way
4 Way
TO FAN
4 Way 3 Way
THE INSPIRE REMOTE CONTROL KIT IS COMPATIBLE
WITH INSPIRE CEILING FANS ONLY.

2
Compatible Inspire Ceiling Fans
RCF12H4WE Inspire Ceiling Fan Plywood, 4 Blades, 1220 mm, 48“, Hangsure - White
RCF12H4BL Inspire Ceiling Fan Plywood, 4 Blades, 1220 mm, 48“, Hangsure - Black
RCF12H4BS Inspire Ceiling Fan Plywood, 4 Blades, 1220 mm, 48“, Hangsure - Silver
RCFTRI12H4WE Inspire Ceiling Fan Plywood with Light, 4 Blades,1220 mm, 48”, Hangsure - White
RCFTRI12H4BL Inspire Ceiling Fan Plywood with Light, 4 Blades,1220 mm, 48”, Hangsure - Black
4
PRODUCT NOTES
1. This product must be installed by a licensed electrician and used as per these instructions.
2. During installation a switch disconnection should be incorporated in the supply circuit.
3. This product contains no serviceable parts and no attempt should be made to repair this product. If the product is faulty it should be discarded.
4. This product must be cleaned periodically with a damp cloth. Cleaning agents and solvents should never be used.
5. This product has been designed to operate in ambient temperatures between 5°C to 40°C.
6. The fans must be securely attached to a structural member for support. Fixing means (hooks & brackets) must be fixed to the structural member
with sufficient strength to with stand 4 times the weight of the ceiling fan.
7. This product is not suitable for marine environments such as areas subjected to salt spray and/or mist.
8. This product is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they
do not play with the product.
9. Extended exposure to UV rays (such as exposure to direct sunlight) may cause discolouration of this product.
10. The material in this product may vary in colour from batch to batch. Colour matching from one batch to another cannot be guaranteed.
11. This product has been designed to operate on a nominal supply voltage of 230-240 V a.c. 50 Hz.
12. Legrand reserves the right to modify the specification of this product at anytime.
02/2023 LE14169AA
4BATTERY INSTALLATION
■2 x AAA 1.5 V batteries are required to operate the remote control.
■Pull out the battery cover and install the batteries.
■Ensure the polarity is correct as shown in the battery compartment.
■Please remove the batteries if you intend not to use the ceiling fan
for any long periods of time.
Install the fan remote bracket on the wall as shown.
Paper
■ Legrand (“we or us”) has given each purchaser who is a consumer (“you”) a warranty against defects
in its products.
■ As a consumer, you are entitled to the benefit of the Warranty and should read and understand its
terms. In addition, for the purposes of the Australian and New Zealand Consumer Laws, we note the
following:
■Our contact details for the purpose of any claims made
under the Warranty are below. Any claim under the
Warranty must be sent in writing to the following address:
NEW ZEALAND ONLY
Legrand New Zealand Ltd
106-124 Target Rd
GLENFIELD, AUCKLAND
0800 476 009
[e-mail]
AUSTRALIA ONLY
Legrand Australia Pty Ltd
Nexus Industry Park
Bldg 4, 43-47 Lyn Parade
PRESTONS, NSW 2170
1300 369 777
sales.or[email protected]om.au
Warranty Statements
● If we accept your claim under the Warranty we will reimburse all your reasonable expenses in
making and pursuing the claim, including the cost of reimbursement of any defective products
returned in the ordinary course to us at the address above by post or other agreed means. Any
such claim must be made within 14 days of your receiving notice of our acceptance of your claim
and include any necessary supporting documentation or invoices.
● As a consumer, you have rights under the Australian and New Zealand Consumer Laws and may
have rights under other applicable laws which cannot be excluded, restricted or modified. Those
rights are in addition to any rights you have under the Warranty.
● Legrand warrants this product for a period of 2 years from the date of purchase. Our goods (which
we refer to in the Warranty as the Products) come with guarantees that cannot be excluded under
the Australian and New Zealand Consumer Laws. You are entitled to a replacement or a refund for
a major failure and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
REMOTE CONTROL5
Remote control Mode Operation
Timer
Allows the fan to run for
a further 2/4/8 hours of
operation before switching
OFF automatically.
Does not affect the light
output.
Fan ON Press speed buttons
Fan Speed
3 fan speeds can be selected.
Press any speed control
button (Low, Med or High)
Light ON /OFF
Operation Range 10 m (free air)
ON/OFF
2H
HI
MED
LOW
OFF
4H
8H
Timer
Speed