LEGRAND LUXUL User manual

Access Point Setup Guide
Setting up your AP:
Place the AP in the center
of the desired coverage area
NOTE: If installing this AP with a
wireless controller, refer to the Wireless Controller Setup Guide
Connect a PoE+ Ethernet cable to the AP’s PoE
port (for power, use the included PoE injector
or a compatible PoE+ switch)
AP power
source
router or
switch
IN
OUT
POE
INJECTOR
2.
1.
Connecting Via an Ethernet Device
Use an Ethernet cable to connect your computer to the LAN port
of the AP. Ethernet is the preferred method of connection
Connecting Via a Wireless Device
Connect a wireless client device to the AP’s default wireless
SSID LuxulXXXX* and use the passphrase: luxulwifi
*XXXX corresponds to the model number of the AP
NOTE: If your computer or device isn’t set to obtain an IP address
automatically, you’ll need to set a temporary static IP address
on that device. Set the IP address of your computer to an
address in the 192.168.0.X range and set your subnet mask to
255.255.255.0. You can leave the default gateway/router ip
address blank.
3a.
3b.
Open a web browser and go to 192.168.0.10
Login with the default User Name and password
User Name: admin
Password: admin
SECURITY NOTE: You will be required to
change the default administrator password.
4.

View Luxul’s Privacy policy at:
https://www.legrandav.com/legal/privacy_policy
The marking information is located at the bottom of the apparatus
Copyright and Trademark Notices
No part of this document may be modified or adapted in any way, for any purposes without permission in
writing from Luxul. The material in this document is subject to change without notice. Luxul reserves the
right to make changes to any product to improve reliability, function, or design. No license is granted,
either expressly or by implication or otherwise under any Luxul intellectual property rights. An implied
license only exists for equipment, circuits and subsystems contained in this or any Luxul product.
© Copyright 2021 Legrand AV Inc. All rights reserved. The name Luxul, the Luxul logo, the Luxul logo
mark and Simply Connected are all trademarks and or registered trademarks of Legrand AV Inc.
All other trademarks and registered trademarks are property of their respective holders.
Technical Support
P: 801-822-5450
E: [email protected]
Support chat: LegrandAV.com click ‘Live Chat’
(upper right) and select Luxul under ‘Brand’
Sales
P: 801-822-5450
E: [email protected]
I need to restore factory default settings?
To restore factory default settings to your AP, press and
hold the button labeled ‘RESET’ until the green system LED
starts flashing (5 seconds)
I need to restart my AP?
To restart your AP, press and quickly release the button
labeled ‘RESET’
I want to perform advanced configuration?
1. Open a web browser and go to 192.168.0.10 or the IP
address you specified during the setup process
2. Enter the login credentials you created during the
setup process
What if... What do the LEDs on my AP indicate?
Indicator State Description
Green
System
LED
On AP is properly connected to power supply
Blinking AP is booting
O Power disconnected or AP is o, or LEDs
are turned o in the web interface
Blue
LEDs
The blue LEDs indicate the status of the wireless broadcast; one for
2.4GHz and the other for 5GHz
On AP is broadcasting a wireless signal
Blinking Indicates wireless activity
O AP is not broadcasting a signal, or the
LEDs are turned o in the web interface