Lennox 91W54 User manual

02/12 506960−01
*2P0212* *P506960-01*
Page 1
Litho U.S.A.
INDOOR AIR QUALITY PRODUCTS
KITS AND ACCESSORIES
506960−01
02/12 GERMICIDAL LIGHT
LAMP BASE KIT (91W54) INSTALLATION FOR GERMICIDAL LIGHT MODELS UVC−24V,
UVC−41W−S, & UVC−41W−D
General
Use these instructions to replace the Germicidal Lamp
Base (kit 91W54).
Shipping & Packing List
Contents
1 − Germicidal light lamp base assembly
1 − UVC lamp base
1 − O−ring
1 − Foil label
1 − Installation instructions
IMPORTANT! Refer to Installation Instructions
506038−01 or 506830−01 for the complete installation
instructions!
Required Tools and Unique Supplies
SPhillips screwdriver
WARNING
Risk of property damage, injury, or death.
Installation, adjustments, alterations, service and
maintenance must be performed by a licensed pro-
fessional service technician (or equivalent).
WARNING
Electric shock hazard.
Can cause injury or death.
Disconnect all remote power supplies
before opening any unit access panels.
Unit may have multiple power supplies.
Do not operate without access panels
in place.
DANGER
Ultraviolet (UVC) Radiation Hazard.
Any exposure will cause significant eye damage
and may cause skin damage.
DO NOT look into UVC light source.
Access panels must be in place during appliance
operation.
CAUTION
Lamps Contain Mercury.
Ingestion or contact with mercury or mercury vapor
is hazardous to your health.
Take care when handling lamps. If lamp is broken,
avoid contact with mercury.

Page 2
506960−−01 02/12
Installation
ENHANCED
BALLAST
CORD
LAMP CORD
CONNECTOR
DISCONNECT
CONNECT
Figure 1. Disconnect/Connect Lamp Cord
LOCK POSITION
ALIGN
POSITION
LAMP
BASE
LAMP
HOLDER
1" HOLE
ROTATE TO UNLOCK
Figure 2. Removing the lamp holder assembly
1. Turn off power to the lamp before removing the cord.
2. Disconnect the lamp cord as shown in figure 1.
3. Unlock the lamp holder as shown in figure 2. Set the
lamp holder and lamp aside.
4. Remove the lamp base as shown in figure 3.
5. Install new lamp base assembly as shown in figure 3.
LAMP BASE MOUNTING
SCREWS
I INCH
HOLE
Figure 3. Remove and Install Lamp Base
BAFFLE
TROUGH
LAMP
SCREWS
MOUNTING
SURFACE
LAMP BASE
GUIDE LAMP TIP ALONG
THE SURFACE OF THE
TROUGH
LAMP
HOLDER BAND
CLASP
Figure 4. Guiding Lamp into Shielding Baffle
6. Align arrow on lamp holder with arrow on lamp base.
Insert lamp holder into base (see A in figure 5).
7. Twist to align lamp holder arrow with lock symbol (see
B in figure 5).
LAMP
BASE
APPROX.
30 DEG.
ROTATION
AB
Figure 5. Locking Lamp in Place
8. Connect the lamp holder cord’s quick connect to the
mating enhanced ballast connector (see figure 1).
9. Turn on power and check operation and that LEDs on
ballast are lit.