LevelOne WBR-3601 User manual

WBR-3601
54M Wireless ADSL2+ Modem Router
Quick Installation Guide
English
France
German
Spanish
Italian
Danish
Dutch
Greek

2
English.......................................................................3
Deutsch....................................................................12
Italiano .....................................................................21
Nederlands .............................................................. 30
Français...................................................................39
Español....................................................................50
Dansk.......................................................................59
 ..................................................................68

3
Package Contents
WBR-3601
Power Adapter (12V AC, 1A)
RJ-11 ADSL / Telephone Cable
RJ-45 LAN Ethernet Cable
CD-ROM with Manual / Utility
Quick Installation Guide
If any of the above items are missing, please contact your retailer
or distributor.

password details ready.
Default Settings
IP Address
192.168.0.1
User/Password
admin / password
Wireless Mode
Enable
Wireless SSID
WBR-3601
Security
None
English

4
Installation
1. Connect the ADSL activated Telephone line
2. Connect the Computer LAN cable to an available LAN port.

5
3. Plug in the Power Adapter
4. Press the Power ON switch on the rear of the router.

6
5. Wait until the PWR and ADSL Link lights remain lit green (not
blinking) and the relevant LAN is lit.
Note: If the ADSL Link light continues to blink, it means that that router cannot find
an active ADSL connection. Please contact your Internet Service Provider for
support.
6. Installation is now complete. You can now begin to set up the
device.

7
Setup
1. Start your WEB browser. In the Address box, enter the
following:
http://192.168.0.1
2. When prompted, use the following username and password.
User Name: admin
Password: password

8
3. The first time you connect to the WBR-3601, you should run
the Quick Start Wizard to configure the ADSL and Internet
Connection. Click Quick Start on the menu.
4. Please create a new password for the router.
Leaving it as default could be a security risk.
5. Select your Time Zone.

9
6. There are many ways to connect to your Internet Service
Provider. Please refer to the table below to ensure your
choices are correct.
In all cases, you will be required to enter the VPI and VCI
settings. This must be provided to you by your Internet Service
Provider.
Connection Type
Data required.
Dynamic IP Address
Usually, none.
Static (Fixed) IP
Address
IP Address allocated to you, and
related information, such as Network
Mask, Gateway IP address, and DNS
address.
PPPoE, PPPoA
a) User name and password are
always required.
b) If using a Static (Fixed) IP address,
you need the IP address and related
information (Network Mask, Gateway
IP address, and DNS address)
Bridge Mode
The authentication process is not done
by the WBR-3601, but by another
device or PC. Note that the router and
firewall functions do not apply under
this mode.

10
7. When the Quick Start Wizard is complete, click  to save
the settings and restart the router. You will be required to enter
your new password.
Click to exit the Quick Start Wizard.
8. If successful, the Internet light should now be on.
Now you can access the Internet.