LevelOne Infinity IFS-0501 User manual

5-
Port Fast Ethernet Industrial Switch
Quick Installation Guide
IFS-0501
Port Fast Ethernet Industrial Switch
Quick Installation Guide
Quick Installation Guide
v1.0
IFS-0501 Page 1
Overview
The LevelOne IFS-0501 Industrial Fast Ethernet Switch
provides 5 ports at 10/100M TX to enable high speed network
in mission-critical environments. With an industrial standard
DIN-rail mount, this switch can be installed in a cabinet, and
clearly visible status LEDs provide simple monitoring of port link
activity. The switch is housed in a solid metal case rated at
IP30, keeping it safe from dust, vibration, heat and humidity,
while an operational temperature range of -40°C to +75°C
makes it suitable for deployment in almost any environment.
High Reliability
All components are built to withstand harsh environment
applications without compromise where humidity, temperature
variation and even shock vibration are concerns, including
Electric & Utility, Critical Infrastructure, Transportation and
Surveillance Security. This device operates under -40 to 75
Celsius (-40 to 167 Fahrenheit) temperature.
Plug & Play
This unmanaged Industrial Ethernet Switch is designed for the
demanding industrial environments at businesses in need of
instant connectivity with no setup or configure required, truly
plug and play.
IFS-0501 Page 2
Features
•Meets NEMA TS1/TS2 Environmental requirements such as temperature,
shock, and vibration for traffic control equipment
•Meets EN61000-6-2 & EN61000-6-4 EMC Generic Standard Immunity for
industrial environment
•Supports 1024 MAC addresses. Provides 1M bits memory buffer
•Store-and-forward mechanism. Full wire-speed forwarding rate.
•Power Supply: 9~56VDC Terminal Block power input.
•3.76W power consumption 48VDC full load
•-40℃to 75℃(-40℉to 167℉) operating temperature range.
•Tested for functional operation @ -40℃to 85℃(-40℉to 185℉).
•Metal case design and compliant with IP30 standard
Package Contents
IFS-0501
Din rail*1, wall mount*2, terminal block*1, screw*4
Quick Installation Guide
IFS-0501 Page 3
LED Status
LED
Status
Description
PWR 1, 2 ON Power On
OFF Power Off
SW (relay) ON both PW1 and PW2 are connected
OFF only PW1 or PW2 is connected
10/100
/
Base
-
TX
LNK(1 ~ T5)
ON TX link is detected
OFF TX port is not detected
Flashing TX port is active

IFS-0501 Page 4
Power Input
Terminal Block
PW1
+
44–56VDC
–
Power Ground
PW2
+
44–56VDC
–
Power Ground
Relay Output 1A @ 24VDC
IFS-0501 Page 5
DIN Rail Mount
•Assembly: Place the switch on the DIN rail from above using
the slot. Push the front of the switch toward the mounting
surface until it audibly snaps into place
•Start-up: Connect the supply voltage to start up the switch
via the terminal block (or DC JACK)
•Dismantling: Pull out the lower edge and then remove the
switch from the DIN rail.
IFS-0501 Page 6
10/100Base-TX Connector
The following lists the pin-out of 10/100Base-TX ports.
Pin
Standard Port
Uplink Port
1 Output Transmit Data + Input Receive Data +
2 Output Transmit Data - Input Receive Data -
3 Input Receive Data + Output Transmit Data +
4 NC NC
5 NC NC
6 Input Receive Data - Output Transmit Data -
7 NC NC
8 NC NC