Leviton AEMRK User manual

Multi-Room Install Kit
Cat. No.
AEMRK
USER GUIDE
DI-000-AEMRK-00A
For additional information, contact Leviton’s Techline at
1-800-824-3005 or visit Leviton’s website at www.leviton.com
LIMITED 5 YEAR WARRANTY AND EXCLUSIONS
Leviton warrants to the original consumer purchaser and not for the benefit of anyone
else that this product at the time of its sale by Leviton is free of defects in materials
and workmanship under normal and proper use for five years from the purchase date.
Leviton’s only obligation is to correct such defects by repair or replacement, at its option,
if within such five year period the product is returned prepaid, with proof of purchase
date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality
Assurance Department, 59-25 Little Neck Parkway, Little Neck, New York 11362-
2591. This warranty excludes and there is disclaimed liability for labor for removal of
this product or reinstallation. This warranty is void if this product is installed improperly
or in an improper environment, overloaded, misused, opened, abused, or altered in any
manner, or is not used under normal operating conditions or not in accordance with any
labels or instructions. There are no other or implied warranties of any kind, including
merchantability and fitness for a particular purpose, but if any implied warranty is
required by the applicable jurisdiction, the duration of any such implied warranty, including
merchantability and fitness for a particular purpose, is limited to five years. Leviton is not
liable for incidental, indirect, special, or consequential damages, including without
limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay
or failure to perform this warranty obligation. The remedies provided herein are the
exclusive remedies under this warranty, whether based on contract, tort or otherwise.
DI-000-AEMRK-00A
Right
Left

OVERVIEW
The Leviton Multi-Room Audio Plate provides a convenient
method of terminating in-wall speaker wires to installed
speakers and cables from amplifier speaker outputs. The
wallplate also has two QuickPorts that can be used for any
of the full line of QuickPort jacks.
1. Install a single-gang low-voltage ring at amplifier location.
2. Run a minimum of 16/4 Class 3 speaker wire from Multi-
Room Audio Wallplate location to the audio distribution
module being used in the Structured Media enclosure.
Minimum Gauge Lengths are as follows:
WIRE LENGTH RECOMMENDED SIZE
Up to 50 feet (15 m) 18-gauge
50-150 feet (15-45 m) 16-gauge
Over 150 feet (45 m) 14-gauge
NOTE: The smaller the wire gauge number is, the thicker
the wire is.
TO TRIM-OUT:
3. Connect the left and right speaker wires to their
corresponding connectors on the back of the Multi-Room
Audio Wallplate.
4. Connect amplifier speaker outputs to corresponding
spring post connectors on the Multi-Room Audio
Wallplate by stripping approximately one inch of
insulation from the speaker wire. Push in the spring post
until the holes in the post line up and insert bare portion
of wire through the hole and release spring post. Spring
pressure will maintain contact on the speaker wire.
NOTE: Red is positive, Black is negative.
5. Complete volume control and speaker wiring per
manufacturer’s instructions
WIRING DIAGRAM EXAMPLE
Stereo Amplifier
Left Right

This page is NOT to be printed in the booklet
DOCUMENTATION
LEVITON INSTRUCTION SHEET/MANUAL
SPECIFICATIONS
KKC 04/05/06
Helvetica
DI-000-AEMRK-00A
Black
N/A
Final fold size:
50 lb. offset
Overall size:
8.0" x 6.0"
4.0" x 6.0"
Paper size:
4.0"
6.0"
4.0"
6.0"
FINAL SIZE
Cat. No.
OVERALL SIZE
8.0"
6.0"
4.0"
3.0"