LG LT1033HNR User manual

your air conditioner and retain it for future reference.
TYPE WINDOW
MODELS LT1033HNR, LT1233HNR
P/NO MFL67694003

Before to Operation

Do not store flammables like
gasoline benzene thinner
etc. near the air conditioner.

No correlation between fan
usage and oxygen depletion.
Unplug the unit when not
using it for a long time.

For inner cleaning, contact an Authorized Service Center or a dealer.
Do not use harsh detergent that causes corrosion or damage on the unit.
Harsh detergent may also cause failure of product, fire, or electric shock.
Be considerate.
Follow installation instructions exactly.
Install the product so the exhaust and noise
are not aimed directly at the neighbors.

y
If you eat the liquid from the battery,brush
your teeth and see doctor.Do not use the
remote if the battery have leaked.
y
Do not use this appliance for
special purposes such as
cooling pets foods，
precision
machinery，or objects of art
，
Instead of running air conditioning
constantly，open a window
for fresh air occasionally.
You will feel better.
If the liquid from the battery gets onto your skin
or clothers，
wash it well with clean water. Do
not use the remote if the battery has leaked.

7
2. No correlation between fan usage and oxygen depletion.
3.

Electric Heater

RESET
TEST
should be
Avoid shock hazard. This unit cannot
be user-serviced. Do N27 open the
tamper-resistant sealed portion.
All warranties and performance will
be voided. This unit is not intended
to be used as an ON/OFF switch.

（Figure 1）
（Figure 2）
Figure 1
Figure 2

Figure 3
air
conditioner
air conditioner.

3
Figure 4
Figure 5
Figure 6
Figure 7

Figure 8.
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12

in Figure 13.
Figure 13
Figure 14

Figure 15
Figure 15.
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20

Figure 22.
Figure 21
Figure 22
Figure 23

REMOTE CONTROLLER
Power
Temp
Fan Speed
Timer Mode
- when the air conditioner is off, it can be set to automatically turn
OPERATION MODE SELECTOR
the desired fan speed.
Delay OFF - when the air conditioner is on, it can be set to automatically turn
on from 1 to 24 hours at its previous mode and fan settings.
off from 1 to 24 hours.
Everytime you push this button，it will toggle between Cool, Energy Saver, Fan, and Heat.
Delay ON
ON/OFF TIMER
Cool - Compressor runs and cools the room. Use the and FAN buttons to
set the desired temperature and circulation fan speed.
Energy Saver - The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Fan - Fan circulates air but compressor does not run. Use the FAN button to set
Operation starts when this button is pressed and stops when you
press the button again.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), High (F2).
POWER

Heat
-
Fan runs continually for normal heating operation.
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
REMOTE CONTROL SENSOR
During operation in failure of electric power, the unit runs as previous setting operation.
Do not use rechargeable battery. Make sure that the batteries is new.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium)
batteries.
- In order to prevent discharge, remove the batteries from the remote control if
the air conditioner is not going to be used for an extended period of time.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
Keep the remote control away from extremely hot or humid places.
1. Push out the cover on the back of the remote control with your thumb.
2. Pay attention to polarity and insert one new AAA 1.5V batteries.
3. Reattach the cover.
CAUTION
The remote controller will not function properly if strong light strikes the sensor of the air
conditioner or if there are obstacles between the remote controller and the air conditioner.

VERTICAL AIR-DIRECTION CONTROL
HORIZONTAL AIR- DIRECTION
CONTROL