LG LT1036HNR User manual

www.lg.com
OWNER’S MANUAL
Please read this manual carefully before operating
your set and retain it for future reference.
TYPE : WINDOW
AIR
CONDITIONER
MODELS LT1036HNR LT1236HNR
P/NO : MFL68744001
NORSK SUOMI DANSK

Before to Operation

Do not store flammables like
gasoline benzene thinner
etc. near the air conditioner.

No correlation between fan
usage and oxygen depletion.
Unplug the unit when not
using it for a long time.

For inner cleaning, contact an Authorized Service Center or a dealer.
Do not use harsh detergent that causes corrosion or damage on the unit.
Harsh detergent may also cause failure of product, fire, or electric shock.
Be considerate.
Follow installation instructions exactly.
Install the product so the exhaust and noise
are not aimed directly at the neighbors.

y
If you eat the liquid from the battery,brush
your teeth and see doctor.Do not use the
remote if the battery have leaked.
y
Do not use this appliance for
special purposes such as
cooling pets foods，
precision
machinery，or objects of art
，
Instead of running air conditioning
constantly，open a window
for fresh air occasionally.
You will feel better.
If the liquid from the battery gets onto your skin
or clothers，
wash it well with clean water. Do
not use the remote if the battery has leaked.

2. No correlation between fan usage and oxygen depletion.
3.
7

Electric Heater

RESET
TEST
should
Avoid shock hazard. This unit cannot
be user-serviced. Do NOT open the
tamper-resistant sealed portion.
All warranties and performance will
be voided. This unit is not intended
to be used as an ON/OFF switch.
USE OF EXTENSION CORDS
RISK OF FIRE could cause serious injury or death
DO NOT use an extension cord with this window
air conditioner
DO NOT use surge protectors or multi-outlet
adapters with this window air conditioner
be

（Figure 1）
（Figure 2）
Figure 1
Figure 2

Figure 3
air
conditioner
air conditioner.

3
Figure 4
Figure 5
Figure 6
Figure 7

Figure 8.
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12

in Figure 13.
Figure 13
Figure 14

Figure 15
Figure 15.
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20

Figure 22.
Figure 21
Figure 22
Figure 23

REMOTE CONTROLLER
Temp
Fan Speed
Timer Mode
- when the air conditioner is off, it can be set to automatically turn
OPERATION MODE SELECTOR
Delay OFF - when the air conditioner is on, it can be set to automatically turn
on from 1 to 24 hours at its previous mode and fan settings.
off from 1 to 24 hours.
Delay ON
ON/OFF TIMER
Operation starts when this button is pressed and stops when you
press the button again.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), High (F2).
POWER
7
the desired fan speed.
Cool - Compressor runs and cools the room. Use the and FAN buttons
to set the desired temperature and circulation fan speed.
Energy Saver - The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Fan - Fan circulates air but compressor does not run. Use the FAN button to set
Push the MODE button to rotate between Energy Saver / Cool / Fan / Heat.

Heat
-
Fan runs continually for normal heating operation.
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
REMOTE CONTROL SENSOR
CLEAN FILTER
7
After cleaning the filter, press “Temp ” together to turn off ‘Clean Filter’ light.
(Filter reset must be done from unit control panel not remote control).
The unit defaults to Energy Saver mode each time the unit is switched on except
restoration after an electrical power outage and fan mode.
ENERGY SAVER
‘Clean Filter’ LED will light up to notify you that your filter needs to be cleaned.
During operation in failure of electric power, the unit runs as previous setting operation.
This feature is reminder to clean the Air Filter (See Maintenance) for more efficient operation.
The LED (light) will illuminate after 250 hours of operation.
ENERGY SAVER
CAUTION
Do not ure rechargeable battery. Make sure that the battery is new.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium)
battery.
- In order to prevent discharge, remove the batteries from the remote control if
the air conditioner is not going to be used for an extended period of time.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
Keep the remote control away from extremely hot or humid places.
1. Push out the cover on the back of the remote control with your thumb.
2. Pay attention to polarity and insert one new AAA 1.5V battery.
3. Reattach the cover.
The remote controller will not function properly if strong light strikes the sensor of the air
conditioner or if there are obstacles between the remote controller and the air conditioner.
Battery

VERTICAL AIR-DIRECTION CONTROL
HORIZONTAL AIR- DIRECTION
CONTROL