LG G5 Verizon Assembly instructions

LG G5
REPAIR GUIDE
Version 1
2016 Edition

RiAna Soto
Repair Training Specialist
[email protected]
LG G5 REPAIR GUIDE
LCD AND DIGITIZER REPLACEMENT

FOR EVERY REPAIR
MAKE SURE TO COMPLETE, INITIAL,
AND HAVE CUSTOMER SIGN THE CELLAIRIS
REPAIR LIABILITY WAIVER FORM

PRE-REPAIR DEVICE CHECK-IN

•Philips screwdriver
•Spudger
•Tweezers
•Isesamo
•Pentalobe screwdriver
•Magnetic Mat
•LG G5 Digitizer/LCD
TOOLS NEEDED

•Always operate the heat gun on the lowest setting.
•Keep face, hands, hair, and clothing away from the air stream.
•The air nozzle also becomes extremely hot. Never grab the heat gun by the nozzle.
•Never operate the heat gun by laying it on its side on a table. It should be firmly grasped in one hand
at all times during usage.
•Never operate near flammable or explosive liquids and vapors. Cleaning supplies and the 3M #94
Primer are of concern. Make sure fumes are absent from the work area before operating the heat gun
•The heat gun nozzle should never get closer than 2“ to the object being heated.
•Keep heat gun moving. Never stay in one spot.
HEAT-GUN PRECAUTIONS

•Magnetic Pad: During the repair, you will be utilizing a magnetic pad to organize the plethora of
differing screws that you will be pulling out of the iPhone 6S. Below is a list of several internal
components of the iPhone 6S that should never be placed on the pad, or you risk damaging the
hardware or erasing client data:
•LCD/Digitizer Assembly
•Cameras
•Motherboard
•Battery
•Speaker
ADDITIONAL PRECAUTIONS

•Power on/off: To avoid any damage to the hardware during the repair, it is best to have the device
powered off until you can get to and disconnect the battery.
•Battery: Never unplug any flex cables unless the battery has been completely disconnected to avoid
frying your hardware. Do not plug the battery back until all cables have been reconnected.
•Release Screws: Apply pressure on the screw and twist counterclockwise to initially loosen it, then
lighten the pressure and continue twisting until the screw is gently released. Make sure you have
properly sized screwdrivers available for the repair.
•Pin Connectors: extremely fragile and must be plugged or unplugged with extreme caution.
•Battery connector: held down by light adhesive and solder. If not cautious it will come off the
motherboard. Very time consuming to be repaired. Do not break it in the first place.
•Motherboard: small surface mount components can be easily damaged if they are nicked by the
spudger. Always take your time and never touch the surface of the motherboard.
ADDITIONAL PRECAUTIONS

STEP 1
•Remove the battery by holding battery release button (located on the bottom left side of the
device) and pull the bottom of device from the phone. This will expose the battery.
Disassemble the device
Tools: Pentalobe screwdriver

STEP 2
•Next, remove the sim card by using
sim card remover. The sim card is
located on the right side of the
device.
•Remove the two (2) Philips screws
located on the bottom portion of
the phone exposed after removing
the battery.
Tools: Isesamo