Life Smart LS1000-2 User manual

LIFESMART Infrared Heater
User’s Manual
Model# LS1000-2
FOR INDOOR USE ONLY
120VAC15AMPDEDICATEDCIRCUIT
The LIFESMART Infrared Heater works with your in‐home furnace to provide supplement
heat. Carefully and thoroughly read this manual before using the LIFESMART Infrared
Heater for the first time. We recommend keeping this manual for regular review and future
reference. Heater is intended for residential use.

2
Thank you for choosing a LIFESMART Infrared Zone Heating System. This owner’s manual will provide
you with valuable information necessary for the proper care and maintenance of your new product. Please
take a few moments to thoroughly read the instructions and familiarize yourself with all the operational
aspects of your new heater.
IMPORTANT INSTRUCTIONS
When using this electric unit, basic safety precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
1. Read ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.
3. This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If
provided, use handles when moving this heater.
4. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, and curtains at least
3 ft from the front of the heater and keep them away from the sides, top, and rear. DO NOT place
towels or other objects on the heater.
5. Extreme caution is necessary when any heater is used by or near children or the disabled, or when
the heater is left operating and unattended.
6. DO NOT operate any heater with a damaged cord or after the heater malfunctions, has been
dropped or damaged in any manner. Return heater to authorized service facility for examination,
electrical or mechanical adjustment, or repair.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
NEVER locate heater where it may fall into a bathtub or other water container. To protect against
electrical hazards, DO NOT immerse in water or other liquids.
8. DO NOT touch the control panel or plug with a wet hand.
9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner. DO NOT use
on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint,
explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and
open flames.
13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the cord shall be No. 16 AWG minimum size and
rated not less than 1500W.
14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug,
DO NOT unplug by pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17. Use only for intended household use as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not
recommended or sold by unauthorized dealers may cause hazards.

3
18. Always use on a dry, level surface. Use on floor only.
19. DO NOT use outdoors.
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state
speed control device.
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so
will void your warranty. The inside of the unit contains no user serviceable parts. Qualified
personnel should perform all servicing only.
22. Connect to properly grounded outlets only.
23. .Save these instructions.
SPECIFICATIONS
Voltage Rating 120 V (60Hz)
Power Consumption 1500W
Unit Size 13.1 in. (W) x 16.5 in. (D) x 16.7 in. (H)
Unit Weight 22.7 lbs
SAFETY FEATURES
Tip-Over Safety Feature
This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will
automatically shut the heater off. Once the heater is restored an upright position, the heater will reset. To
continue operation, turn on the heater using the supplied remote control or the control panel on the heater.
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heaters internal components reach a
certain temperature that could cause overheat and possible fire, the heater will automatically shut off.
WARNING: This heater has a voltage rating of
120 volts. The cord has a plug as shown in A. An
adapter as shown in C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The grounding lug extending from the
adapter must be connected to a permanent ground
such as a properly grounded outlet box. The
adapter should not be used if a three-slot grounded
receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF
THE GROUNDED PLUG.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the
outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different
outlet. Contact a qualified electrician to inspect the original outlet for damage.

4
IN THE BOX
·HEATING SYSTEM
·INSTRUCTION BOOKLET
PRODUCT DIAGRAM
Temp.
Power
ON/OFF
℃/℉
℃
℉
1、Celsius indicating light
2、Fahrenheit indicating light
3、Digital display：indicate set room temperature
4、Power indication Light：indicate when the unit connects to power supply.
5、ON/OFF switch button: for power ON or OFF.
6、℃/℉Button (Button for alternating between Fahrenheit and Celsius).
7、Temp up button: for setting temp upward.
8、Temp down button: for setting temp downward.
Air Outlet
Front Panel
Control Panel
Wheel
Control Panel
6
3
4
5
78
2
1
Air Intake
Cord Clamp
Power Switch

5
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. and turn on the
power switch in the rear of the unit. Only operate heater in upright position with caster wheels attached.
OPERATING INSTRUCTIONS
1、Start
Turn the heater on by pressing the ON/OFF button on the
control panel
2、Setting room temperature
Or
Adjust the thermostat by pressing the arrows on the control
panel or remote control.
Or
Set temperature indication varies from 86℉to 59℉，or
from 30℃to 15℃. Once you have chosen the desired
temperature, the heater will remain on until the room
temperature increases to the temperature on the digital
display. The heater will cycle on and off to maintain the
desired room temperature.
Press ℃/℉button, then digital display will indicate
Fahrenheit value or Celsius value.
When Fahrenheit indicating light’s on, digital display
indicates Fahrenheit value,
When Celsius indicating light’s on, digital display
indicates Celsius value.
3、Setting electro lock
Function of electro lock can avoid misoperation from children. Locking can be set in both power-on and
power-off modes.
And
Press Temp Up and Temp Down buttons once for 3
seconds. Locking is fulfilled when a buzzer rings. When
locked, control panel and remote control failed to function.
And
When release is needed, please re-press Temp Up and
Temp Down buttons once for 3 seconds. Release is fulfilled
when a buzzer rings. Lock indication disappears. Control
panel and remote control return to function.

6
MAINTENANCE
1. Turn off the power switch in the rear of the unit.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a
mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let
liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the
heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
7. Air filter needs cleaning after used 3 months. Please take down the filter as following steps. Flush
and clean the taken –down filter with water ,then dry it out and re-assemble.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original
packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of service:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working.
NOTE: The heater may not be operating if the thermostat is set higher than the room temperature.
To begin operation, increase the thermostat temperature for a higher heat setting.
Air filterThe unit
Fixing panel
Fixing screws