Lift Tech Marine AC User manual

PWC
Installation Guide
AC AND DC
1. Lower the Boat Lift and
Remove the Old Winch.
2. Remove Black Protective
Cover from the New Winch.
3. Install the Bracket and
New Winch as Shown Above.
Mounting bolts are provided if
you need them.
6. Install the Shaft into the
Spacer Collar. Make Sure the
Spacer Collar and Shaft are
Tight. Use Vise Grip if needed.
4. Install the Cable to
the Winch.
5. Install the Spacer
Collar with the Tappered
End Closest to the
Winch.
7. Install the Fiber Disc.
8. Install the Protective
Cover.
*The PWC motor shows a keyway, but we do not use it for the installation. When the
lift is going up the gear head bolt needs to be spinning clockwise. If it is not, there is a
chance the motor will loosen itself over time and spin off.
9. Install the Teardrop
Bracket onto the Back of
the Motor and Tighten.
10. Slide Motor onto the Shaft.
Install Bolt and Washer into
Teardrop and Bracket. Tighten
with Nut. Install Bolt and Washer
into Motor and Tighten.
AC Needs to be GFI Protected. Recommended extension cords up to 150
feet 12/3. You can only us one battery on the PWC DC.
WWW.LIFTTECHMARINE.COM

PWC
Installation Guide
Winch Upside Down
1. Lower the Boat Lift and Remove Old Winch.
2. Remove Black Protective Cover from the
New Winch.
3. Install the Bracket and New Winch as
Shown Above. (Mounting Bolts Provided if
Needed) Do Not Tighten the Drum Bolt as you
Will Need to Remove it Again to Install the
Protective Cover.
4. Install the Cable to the Winch.
5. Install the Spacer Collar with the
Tappered End Closest to the Winch.
6. Install the Shaft into the Spacer
Collar. Make Sure the Spacer Collar
and Shaft are Tight. Use Vise Grip
if needed.
7. Install the Fiber Disc.
8. Install the Protective
Cover and Tighten the
Drum Bolt.
*The PWC motor shows a keyway, but we do not use it for the installation. When the
lift is going up the gear head bolt needs to be spinning clockwise. If it is not, there is a
chance the motor will loosen itself over time and spin off.
9. Install the Teardrop
Bracket With the Bolts
Provided onto the
Back of the Motor and
Tighten.
10. Slide Motor onto the Shaft.
Install Bolt and Washer into
Teardrop and Bracket. Tighten
with Nut. Install Bolt and Washer
into Motor and Tighten.
AC Needs to be GFI Protected. Recommended extension cords up to 150
feet 12/3. You can only us one battery on the PWC DC.
WWW.LIFTTECHMARINE.COM