Lightolier LYTECEL - EL LUMINAIRE User manual

Lightolier
45 I DUSTRIAL WAY, WILMI GTO , MA 01887
INSTALLATION INSTRUCTIONS FOR THE LYTECEL.-.EL LUMINAIRE
NOTE: Fixture should be installed by a qualified electrician
© Lightolier 2007 59-31160-000 Printed in U.S.A.
HA GER MOU TI G LOCATIO S
2
FEED E D / CO TI UOUS E D
1
46-5/16" (1202mm)
Feed End
4'
Unit
8'
Unit
4'
Unit
8'
Unit
Feed End Continuous End
Wago Plug-in
Wirenuts
4
TO REMOVE LOUVER, follow arrows 1, 2 and 3. To
install Louver, reverse the procedure. For
continuous row mounting, remove End Cap as
shown. Use End Cap for end of row fixture.
3
ut (4)
Washer (4)
Fixture
Threaded
Stud (2)
Wago Plug-in
Supplied
#14 Gauge
Maximum Wire
Solid or
Stranded
End Cap
Threaded
Stud End Cap
Tab (2)
Louver
Fixture
ut
End
Cap
FOR CO TI UOUS ROW MOU TI G, assemble
Fixtures using Threaded Studs (2), Washers (4),
and uts (4) from supply pack included. Make
plug-in wire connections.
1
2
3
94-9/16" (2402mm) Hanger location for individual unit
95-1/4" (2419mm) Beginning or end of row and hanger location
Washer
96-19/64" (2446mm)
Hanger location in
continuous row
Twist-on Wirenuts
Twist-on Wirenuts
Wago Plug-in
Wirenuts
Continuous End

Washer
ut
Step 3
Attach both the washers
and nuts to the two
Threaded Studs.
TO LEVEL FIXTURE, loosen Knurled Screw,
adjust to required position, tighten Knurled
Screw to secure.
6
5
Canopy
Press
Here Stainless
Steel
Cable
Spring-
loaded
Glider
Fixture
Detail A
Cut-off
Excess
Cable
Knurled
Screw
Spring-loaded
Glider
Cable
Fixture
HA GER ASSEMBLY FOR CO TI UOUS ROW
7
Cable
Toggle
for
Fixture B
Step 1
With Fixture suspended
by the Cable at the
opposite end, attach one
end of the Cable with
Toggle into Fixture A.
A
Cable
Threaded
Studs (2)
B
A
Threaded
Studs (2)
Step 2
Install the next Fixture
and attach the Cable End
into Fixture B.
ASSEMBLE HA GER SET FOR BEGI I G OR
CO TI UOUS ROW as shown. To acquire the sus-
pension length, press down on the Spring-
loaded Glider and
release when
proper length is
set. See Detail "A".