Lightolier MD*COFFER MDCG2BX User manual

1. Reading light with low iridescence anodized semi-specular aluminum reflector (flat white interior).
2. Perforated mesh lamp shield with white acrylic overlay.
3. Ambient light with flat white reflector (flat white interior).
4. Twin tube T5 lamps (2).
5. Optional night light 7/9 watt PL.
Wall
12" - 18"
from wall
Ceiling
9'6" max.
mounting
height
2" x 3" access plate with
(2) 7/8" dia. K.O.s Tabs for wire
supports
(4 places)
Mounting holes (8)
23-3/4"
(603mm) 14"
(356mm)
12-3/4"
(324mm)
4-7/8" (124mm)
2-1/32"
(52mm) 19-11/16" (500mm) 2-1/32"
(52mm)
23-3/4" (603mm)
MOUNTING METHODS DIMENSIONS
SSurface
G
Exposed T-grid ceiling
12" - 18"
from wall
Wall angle
or T-bar
(by others)
Wall
Accoustical tile
(by others)
T-bar
(by others)
24"
1
2
3
4
5
48" (1219mm)
6-7/8"
(175mm)
9'-6" max.
ceiling height
Secure fixture
(4 places)
Accoustical tile
(by others)
Mount
Mount
MD*COFFER MDCG2BX
Page 1 of 4 2'x2' RECESSED OR SURFACE, MULTI-FUNCTION PATIENT LIGHTING
INDIRECT AMBIENT LIGHT WITH PERFORATED MESH SHIELD
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Volts/Ballast:
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 SECTION 8/Folio R40-22
FEATURES
• Three integral lighting functions: indirect ambient, direct reading,
and optional night light.
• Precise light control for glare free patient environment.
• Installs as a one-piece unit.
• Recessed or surface mounted to ceiling which eliminates damage to
fixture from hospital equipment attached to patients bed.
• 6 7/8" deep.
• All lamps are shielded.
• All twin tube T5 lamps are accessible for relamping without tools.
• Optional low voltage electronic sequential switch mounted in fixture
for ambient and reading light controlled with pillow speaker
(optional by others).
• Optional Tamper resistant/Germ Shield.
• Meets NYC Code requirements. Chicago Plenum requirements
available.

3" 6" 12"
Wall
Bed
FOOTCANDLES ON BED
FOOTCANDLES ON BED
12"
AMBIENT LIGHT
Indirect illumination from twin tube T5 shielded by perforated mesh shield with white acrylic overlay.
No direct glare to patient.
No direct glare to patients visitor.
No direct glare to adjacent patients.
Lighted
Zone
14 15 15 14 12 12 7
14 16 16 14 12 12 8
14 15 15 14 12 12 7
3" 6" 12"
Wall
Bed
12"
READING LIGHT
Eliminates reflected glare from reading material (over shoulder illumination).
No direct glare to patient or visitors.
Controls light directly onto patients bed.
17 21 23 28 33 6 5
18 22 24 29 35 6 5
17 21 23 28 33 6 5
Lighted
Zone
Illumination at the
reading task ranges 45-
50 footcandles.
MD*COFFER MDCG2BX
Page 2 of 4 2'x2' RECESSED OR SURFACE, MULTI-FUNCTION PATIENT LIGHTING
INDIRECT AMBIENT LIGHT WITH PERFORATED MESH SHIELD
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 SECTION 8/Folio R40-22
Job Information Type:

3" 6" 12"
Wall
Bed
12"
NIGHT LIGHT (Optional)
Indirect 9 or 7 watt PL lamp shielded by perforated mesh with
internal white acrylic overlay.
No glare to any patient.
Wired for independent switching.
OPTIONS
3433221
3433221
3433221
Sequential switch (SW) Pillow speaker (by others)
MD*Coffer’s optional low voltage (1-3 volts) sequential switch mounted in the fixture is listed in compliance
with UL 544 for medical and dental equipment.
SW Option (sequential switch): One red wire with black stripes and one yellow wire from the fixture can be
wired to a wall receptacle (by others) for use with that manufacturers pillow speaker. The pillow speaker is
used to control the television, call the nurse and control the lighting. To control the lighting it should be speci-
fied to have a normally open momentary contact switch.
Pressing this switch on the pillow speaker the first time, turns the ambient light on; pressed a second time,
turns the reading light on and the ambient light off; pressed a third time, turns both the ambient and reading
lights on; pressed a fourth time turns both lights off. Pressing the button again repeats the cycle.
DP Option (individual switches): One red wire, one red wire with black stripes and one yellow wire from the
fixture can be wired to a wall receptacle (by others) for use with manufacturers control systems (such as Hill-
Rom Side Com System). To control the lighting, it should be specified to have a normally open momentary
contact switch.
Pressing the first switch turns the ambient light on; pressed a second time, turns the ambient light off.
Pressing the second switch the first time, turns the reading light on; pressed a second time, turns the reading
light off.
TAMPER RESISTANT/GERM SHIELD
Germ Shield: Ideal for psychiatric wards and germ free environments. Fits lay-in grid
ceiling systems with 15/16" maximum ceiling tee face. The heavy duty welded extruded aluminum frame with
clear 1/8" thick polycarbonate lens is fixture to ceiling system sealed with a heavy duty gasket. Request Folio
R40-15 REV. A.
FOOTCANDLES ON BED
PL9 or PL7 Night Light (PL)
(Lamps not included)
Night Light
MD*COFFER MDCG2BX
Page 3 of 4 2'x2' RECESSED OR SURFACE, MULTI-FUNCTION PATIENT LIGHTING
INDIRECT AMBIENT LIGHT WITH PERFORATED MESH SHIELD
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 SECTION 8/Folio R40-22
Job Information Type:

ORDERING INFORMATION
Explanation of Catalog Number. Example: MDCG2BX120SW
MDC
MD*C
Recessed or
Surface,
Multi-function
Patient Light
with Perforated
Mesh Shield
G
CEILING
TYPE:
Same Unit
May Be Used
For: Grid (lay-in)
Or: Surface
Mounted
2
LAMP
QUANTITY:
(Ambient/
Reading)
2 Lamps
(Total)
BALLAST TYPE:
(Ambient Reading)
20THD 10THD
1 or 2 Lamp Mag. BX* —
1-2 Lamp Elec. SB* IB*
*Instant Start Standard
VOLTAGE:
120 or 277+
OPTIONS:
Add
appropriate
suffix to
catalog no., ie:
SW.
OPTIONS & ACCESSORIES
ACCESS PLATES: Top wiring access plate is shipped with fixture as
standard. When access plates are required in advance for wiring conve-
nience, specify separately. Catalog Number: ACP.
DRYWALL KIT: Order Catalog Number: FK92X2.
Request Folio OA30-10.
ELECTRONIC SEQUENTIAL SWITCH (Low Voltage): Switch factory
mounted in fixture for ambient and reading light convenience (con-
trolled by pillow switch, by others). SUFFIX: SW.
INDIVIDUAL SWITCHING (Low Voltage): Switches
mounted to
patients bed for use with manufacturers control
system (such as Hill-Rom Side Com System). SUFFIX: DP.
9/7 WATT NIGHT LIGHT: SUFFIX: PL (Lamp not included).
FUSING: Internal fast-blow fusing. SUFFIX: GLR.
Internal slow-blow fusing. SUFFIX: GMF.
RADIO INTERFERENCE FILTER: 120 or 277 volt, 50 or 60 Hz. One per
fixture is standard. SUFFIX: RF.
GERM SHIELD. Order Catalog Number: MD4CLGS22.
ELECTRICAL/WIRING OPTIONS: Consult factory.
SPECIFICATIONS
MATERIALS: Chassis parts are die-formed 20 gauge steel.
Reading light – low iridescence anodized 95% reflective, semi-
specular reflector. Ambient light – flat white acrylic contoured steel
reflector and perforated steel mesh shield with white acrylic overlay.
FINISH: Cavity (reading/ambient lights) — flat white acrylic interi-
or, minimum reflectance 86%. Phosphate undercoating. Chassis
exterior — white baked acrylic enamel.
ELECTRICAL: Thermally protected class “P” ballast C.B.M.
approved, non PCB. If K.O. is within 3" of ballast, use wire suitable
for at least 90°.
LABELS: I.B.E.W. UL and ULc Listed.
*Consult factory for 277 volt.
MD*COFFER MDCG2BX
Page 4 of 4 2'x2' RECESSED OR SURFACE, MULTI-FUNCTION PATIENT LIGHTING
INDIRECT AMBIENT LIGHT WITH PERFORATED MESH SHIELD
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 SECTION 8/Folio R40-22
Job Information Type: