Lindy 32569 User manual

2 Port VGA Splitter Pro
User Manual English
LINDY No. 32569
www.lindy.com
Installation
Steps for a single stage installation:
1. Use a high quality HD15 Male/Female video
extension cable to connect the PC’s video
port to the ‘VGA In’ port of the video splitter.
2. Use high quality HD15 Male/Male video
cables to connect the ‘VGA Out’ ports of the
video splitter to the monitors; unless your
monitors have got mounted video cables on
them in which case you would need video
extension cables.
3. Plug the power adapter into an AC source;
and then plug the power adapter cable into
the video splitter’s power jack.
4. Power up the video splitter, power up the
monitors and power up the PC in that order.
Cascading:
To provide video display for more monitors than the
number of available ‘VGA Out’ ports on your video
splitter, additional video splitters can be cascaded.
Use a high quality HD15 Male / Female video
extension cable to connect an available ‘VGA Out’
port on the higher level video splitter to the ‘VGA In’
port of the lower level video splitter. Theoretically
there is no limit to the number of levels in the chain
but be aware that the signal quality may deteriorate
as you add further units further away from the video
signal source.
Note: If you connect a DDC type monitor to ‘VGA
Out’ port No. 1, all other monitors must be able to
support the highest resolution that the DDC monitor
can provide!
Technical Features:
•Video bandwidth 350 MHZ
•Resolution up to 2048 x 1536
•Supports: VGA, S-VGA, XGA, X-VGA,
QXGA and Multi-sync
•Improves signal quality over cable distances
up to 55m
•Supports DDC, DDC2, DDC2B (Port1 only)
•Cascadable
•Full metal housing
•Small form factor
Please note: we recommend using LINDY Premium
or Premium Gold cables in conjunction with our VGA
Splitter Pro range. Please visit our website to view
the full range
Typical Installation Example:
HD15 VGA Cable
from PC to “VGA
In” port
HD15 VGA
Cables from
“VGA Out” port
to monitors

Example of Cascading:
VGA Cable
from PC to
first Splitter
VGA Cable from
first to second
Splitter
VGA Cable from
second to third
Splitter
VGA Cable from
third to fourth
Splitter
Certifications
FCC Certifications
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at their own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation.
CE Certification
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55024 and EN55022 class A for ITE,
EN61000-3-2/-3 the essential protection requirement of Council Directive
89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility.
Recycling Information
WEEE (Waste of Electrical and Electronic Equipment),
Recycling of Electronic Products
United Kingdom
In 2006 the European Union introduced regulations (WEEE) for the
collection and recycling of all waste electrical and electronic equipment.
It is no longer allowable to simply throw away electrical and electronic
equipment. Instead, these products must enter the recycling process.
Each individual EU member state has implemented the WEEE
regulations into national law in slightly different ways. Please follow your
national law when you want to dispose of any electrical or electronic
products. More details can be obtained from your national WEEE
recycling agency.
Germany / Deutschland
Die Europäische Union hat mit der WEEE Direktive umfassende
Regelungen für die Verschrottung und das Recycling von Elektro- und
Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung
im Elektro- und Elektronikgerätegesetz – ElektroG in deutsches Recht
umgesetzt. Dieses Gesetz verbietet vom 24.März 2006 an das
Entsorgen von entsprechenden, auch alten, Elektro- und
Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den
lokalen Sammelsystemen bzw. örtlichen Sammelstellen zugeführt
werden! Dort werden sie kostenlos entgegen genommen. Die Kosten für
den weiteren Recyclingprozess übernimmt die Gesamtheit der
Gerätehersteller.
France
En 2006, l'union Européenne a introduit la nouvelle réglementation
(DEEE) pour le recyclage de tout équipement électrique et électronique.
Chaque Etat membre de l’ Union Européenne a mis en application la
nouvelle réglementation DEEE de manières légèrement différentes.
Veuillez suivre le décret d’application correspondant à l’élimination des
déchets électriques ou électroniques de votre pays.
Italy
Nel 2006 l’unione europea ha introdotto regolamentazioni (WEEE) per la
raccolta e il riciclo di apparecchi elettrici ed elettronici. Non è più
consentito semplicemente gettare queste apparecchiature, devono
essere riciclate. Ogni stato membro dell’ EU ha tramutato le direttive
WEEE in leggi statali in varie misure. Fare riferimento alle leggi del
proprio Stato quando si dispone di un apparecchio elettrico o elettronico.
Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio
del proprio Stato.
LINDY No. 32569
www.lindy.com
Date 30
th
April 2010