Lindy 70543 User manual

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (November 2004)
IDE to
Serial-ATA Devices
User Manual
English
LINDY No. 70543
www.LINDY.com

1. Introduction
This Bridge Board is a converter solution for the Serial ATA Device. It has a standard
22 pin SATA port which can interface to a Serial ATA device (hard disk, CDROM,
DVD, CD-RW, etc). It accepts Parallel ATA (IDE) commands through the 40 pin IDE
connector from the host, decodes the commands and converts them to Serial ATA
commands to the device. Response from the device through the SATA bus are deciphered,
processed and converted to parallel ATA protocol and sent to the host.
The Converter Board supports the Serial ATA Generation 1 transfer rate of 1.5 Gb/s
(150 MB/s) on the serial ATA side and is compatible with Ultra ATA-133 on the parallel
ATA side.
1.1.Features
1.1.1. Overall Features
Compatible with Ultra ATA 133 specifications
Supports all types of SATA storage devices (DVD, DVD-RAM, MO, CD-ROM,
CD-RW, Hard Disk, ….)
1.1.2. Serial ATA Features
Compliant with Serial ATA 1.0 specifications
Supports Serial ATA Generation 1 transfer rate of 1.5Gb/s
Supports Spread Spectrum in receiver
2. Installation
Step 1. Connect Y-type power cable to J1 connector and PC Power Supply
Step 2. Set J3 on M for IDE Master mode or S for IDE Slave mode
Step 3. Attaches 22 pin SATA connector (P1) to the back of SATA Device
Step 4. Connect IDE cable to J2 (40 pin connector) and IDE Host
Important*** J3 must be set on Master Mode for Booting device

This device complies with Part 15 of the FCC Rules.
Operation is subject to the followin
g
two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, includin
g
interference that may cause
undesired operations.