Living Spaces MAS90 Operator's manual

MAS90: 5043-43220
TWIN FRAME HARDWARE
QTY: DESCRIPTION:
81/4 X 4 HEX LAG BLK
83/16 USS FL WASHER BLK
10 6 X 1 1/4 PHIL FLAT PARTICLE BOARD SCREW
7030-00267 KIT

4717/4400 TWIN 4722/4401 FULL
7030-00267
SEDONA
TWIN/FULL CONTEMPO BED
PARTS LIST;
A) 8 -4 1/4" Lag Bolts
B) 8 -Black Steel Washers
C) 1 -Headboard Assembly
D) 1 -Footboard Assembly
E) 2 -5 1/4" x 75” Mattress Rails w/Support Cleats
F) 3 -3 1/2” x 38 3/4”(Twin) or 53 3/4”(Full) Mattress Supports
G) 10 -1 1/4” Wood Screws
TOOLS REQUIRED:
1) 7/16" Wrench or Socket Wrench
2) Phillips Head Screwdriver
Recommended: Electric driver
with 7/16" socket
Make sure you have all parts before beginning assembly. If you need a part, contact the dealer where you
purchased your bed.
1) Attach two mattress rails(E) to headboard assembly(C) and footboard assembly(D) with 8 lag bolts and 8
washers, and tighten.
2) Roll Slat Kit out on bed, stretching from Headboard to Footboard. Secure with 4 wood screws in ends of
outermost two slats, one in each corner of the bed. Center 3 individual slats in the gaps built into the Slat kit,
and secure with wood screws, one on each end of the individual slats.
3) Add a mattress not thicker than 7" and sleep well!

Installation of individual slats for use with Slat Roll (Slat roll sold separately) See your retailer for purchase of Slat Roll
SCREW
SCREW
SCREW
SCREW SCREW SCREW SCREW
SCREW
SCREW
SCREW
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
Installation of individual slats for use with Bunkie Board (Bunkie Board sold separately) See your retailer for purchase of Bunkie Board
SCREWSSCREWSSCREWSSCREWSSCREWSSCREWS
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
When used with a slat roll, the three
individual slats should be placed evenly in the gaps and underneath the strapping before fastening.
Individual Slat
Individual Slat
Individual Slat