
Instruction manual
12
USE
1. A just the height an sprea range of the hanger as require an hang the clothes on it
2. Ensure you appliance is unplugge an switch on OFF position.
3. Remove water tank an fill it with cool water an replace the valve.
D N T USE H T WATER D N T USE APPLIANCE WITH DRY WATER TANK
It is better to use distilled or demineralized water.
4. Place the water tank back into the unit an make sure well fixe .
5. Plug the appliance.
Let the machine preheat for about 40 secon s
.
Note: When the steam tube bending, it happen to emit cooing sound. Water drops may be appeared on
the steam holes and the amount of steam will decrease significantly. Lift the handle for 2-3 seconds in this
case, to correct the problem.
6. Select the suitable steam flow level thanks to the switch, the in icator light will illuminate .
7. Gently press the metal panel of ironing brush on the clothes, move the brush up an own at such a
spee that allows the steam to penetrate into the fibers appropriately to remove wrinkles
8. When operation is finishe , switch OFF the appliance an unplug it.
PRESSING WITH STEAM
1. To steam your garment, place it on a clean clothes hanger an place the hanger on the hanger hook
2. Slowly sli e steam nozzle vertically, from the bottom to the top of garment.
3. Remove the nozzle from the bottom to top of garment an smooth the fabric with your han .
4. Repeat before steps until the fabric is wrinkle free.
5. Curtains can be steame while still hanging
6. To remove stubborn wrinkles the brush may also be use .
Be careful when han ling garments on the hanger, pulling on the garments with too much force may bring
own the unit.