Logitech MKZ260 User manual

Getting started with
Logitech® Wireless Combo
MKZ260 with Speakers

2
Logitech® Wireless Combo MKZ260 with Speakers
AAA
1
Wireless Combo MK260

3
Logitech® Wireless Combo MKZ260 with Speakers
2

4
Logitech® Wireless Combo MKZ260 with Speakers
45678
Features
1. Play/pause
2. Mute volume
3. Decrease volume
4. Increase volume
5. Navigate to Internet home
6. Launch email application
7. Place PC in standby mode
8. Launch calculator
Help with setup
•Check the battery installation in the keyboard
and mouse, or replace the batteries.
•Plug the receiver into a different USB port.
Remove any metal object between the
receiver and the keyboard/mouse that may
interfere with reception.
•Try moving the keyboard/mouse closer to
the receiver.
•If the receiver is plugged into a USB hub,
try plugging it directly into your computer.
•Restart the computer.
•If these suggestions don’t work, download
the Reconnection Utility from http://www.
logitech.com/connect_utility.
Replacing keyboard batteries:
1. Open battery compartment on keyboard
bottom.
2. Remove old batteries.
3. Wait 15 seconds before inserting the new
batteries to allow the keyboard to reset.
4. Follow diagram in battery compartment to
insert two new AAA batteries in keyboard.
Close battery compartment.
Replacing mouse battery:
1. Press on battery compartment door and slide
down to open.
2. Remove old battery.
3. Follow diagram in battery compartment to
insert one new AA battery. Close battery
compartment.
AAA

5
Logitech® Wireless Combo MKZ260 with Speakers
Safety
1. Unplug the speakers from the computer
before cleaning them with a dry cloth.
2. For added protection during lightning storms,
unplug the speakers from the USB port and
turn off the computer.
3. Servicing is required when the apparatus has
been damaged in any way, such as when
the power cord or plug has been damaged,
liquid has been spilled on the apparatus or
objects have fallen into it, or the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
Setting up your Logitech® S-150
Digital USB speakers
1. Connect the USB cable on the right speaker
to an available USB port on your computer.
2. Adjust the volume on your speakers. Volume
Up, Volume Down, and Mute will work with
any audio software application. Mute will
silence the speakers. To release Mute, press
the Mute button again.
Volume controls
1. Volume up
2. Mute
3. Volume down
4. LED indicator
Troubleshooting
Speakers produce weak or no sound.
Is the power light on? Make sure the speakers
are plugged into your computer’s USB port
and the power light is on. Has the computer
recognized your speakers? Open your
computer’s sound mixer program. In Windows®
you’ll find this program opening “Sounds and
Audio Devices” in your Control Panel. Make
sure that “USB Audio Device” is selected in the
hardware settings. You may also unplug the
USB cable and plug it in again. Are the speakers
muted? To release Mute, press Mute again.
Specifications
Total RMS Power: 1 Watt (0.5W + 0.5W)
into 4 ohms at 1 kHz at 10% THD (total
harmonic distortion).
System THD: Better than 10% THD before
clipping.
Signal to noise ratio: >100dB.
Frequency response: 20Hz~20kHz. Driver Size:
2” (5 cm) driver.
S-150 Digital USB Speakers