LONEALERT Man Down X Manual

Man Down X Instruction Guide
Initial man Down X setup
LONEALERT User Guides
GPS LED Flashlight (Green)
A call is coming
A call is coming
A call is coming
in or busy
Sleeping
No GPS fix or
initialising
GPS Fix
Low
battery
Speaker
GPS Indicator
Answer/end call button
SOS button
Lanyard Hole
Volume up
GSM Indicator
Microphone
Volume down
Power button
Micro USB port
Battery
cover
Flashing (every
5 seconds)
Flash (1 second
on, 1 second off)
GPS LED Flashlight (Blue)
Continuous light Charging Continuous light
Off
Fast flash (0.3 sec
on, 0.3 sec off) Off Connected to
GSM network
No GSM signal
or initialising
Sleeping
Flashing (every
5 seconds)
Flash (1 second
on, 1 second off)
Step 7) Replacing the battery cover
Place the battery cover back onto the Man Down
X and use the mini screwdriver to screw it in
place. Take care not to cross-thread the screws.
Step 8) Check the Man Down X
Now that you are ready to check that your Man Down X has been set
up correctly, follow the instructions on the next page.
LED Indications
Step 2) Removing the battery
Lift the battery from the notch at the bottom and pull it out of the Man
Down X towards you.
Step 3) Opening the sim card slot
With the Man Down X lay flat in front of you, there will be 2 silver
components, the one on the left is for the sim card, to open it, slide the
silver component down towards you and fold it up towards you.
Step 1) Removing the battery cover
With the Man Down X turned off, place your Man
Down X with the front facing down. Use the mini
screwdriver (included) to remove the two screws to
release the back cover. Lift the back cover from the
notch at the bottom of the Man Down X.
Step 4) Inserting the sim card
Pop out the micro sim card found within the box
and place it into the Man Down X, (gold side facing
down) making sure the notch in the corner matches
with the sim card holder.
Step 5) Closing the sim card slot
Fold the silver cover down onto the sim and slide it up away from you to
lock the sim in place.
Step 6) Replacing the battery
Place the battery back in the Man Down X with the gold tab matching with
the connectors in the top left of the Man Down X.
To download digital versions of our user guides,
either scan the QR code above, or head to: https://
www.lonealert.co.uk/lonealert-user-guides/
www.LONEALERT.co.uk
[phone]
360-0000Document Reference: 367-2001 - Man Down X complete guide
Please note: GPS location can take a few minutes to find you when you power
your Man Down X up for the very first time. We suggest that before use, you
place it close to an external window or wear it outside for around 30 minutes.

1) Power
Man Down X
Finding this guide difficult to read? You can
download a digital version at:
https://www.lonealert.co.uk/lonealert-user-guides
Power On
Press and hold the power button located on the side of the Man Down X until it
beeps and you see the 2 LED lights turn on.
Power Off
Press and hold the power button until the LED lights go off, then press and hold the
power button again for approx. 3-4 seconds and let go - you should notice the Man
Down X beeps twice to alert you that it has powered off successfully.
2) Timers
Set a timer
Press and hold the + button on the side of the Man Down X until the device vibrates.
Cancel a timer
Press and hold the – button on the side of the Man Down X until the device vibrates.
Update a timer
First you must cancel your timer, then you can set a new timer using the + button.
Set a custom length timer
Press and hold the phone button on the front of the Man Down X until it vibrates and beeps. This will
ring through to our check call service, at which point you will have the following options:
If you fail to update your timer and it elapses, you will receive a
call to your Man Down X or to your phone number registered with
LONEALERT. This is to notify you that your timer has expired and
requires updating to let people know that you are OK.
If the call comes through to your mobile phone, you can enter
your pin code as prompted using your phone’s dial pad - your
timer will be restarted if you had a periodic timer set, or cancelled
if you set a standard timer.
If the call comes to your Man Down X you must end the call by
pressing the phone button, then set a new timer using the +
button or cancel your timer using the – button.
4) End call
If you are currently on a call (e.g. custom
timer function), you can press the phone
button to end the call.
5) Raise Panic
To raise a panic alarm, press and hold the SOS button on the front of the Man Down X for
approx. 2-3 seconds. The Man Down X will beep and vibrate to let you know it has been
pressed, then raise a panic in accordance with your company procedure.
If you have our LONEALERT ARC set as your first point of contact, your Man Down X will
raise a 2 way call with them. If this disconnects, the ARC can call you back.
If your Man Down X is set up to follow your company's internal procedure, the relevant
contacts will receive an automated message, alerting them that you have raised a panic.
This allows them to action the alert and try to get in contact with you.
6) Man Down
If the Man Down X is tilted over approx. 45 degrees for 10 seconds, it will begin beeping at the wearer. To stop this, simply tilt the Man Down
X back upright and after a few seconds it should stop beeping and return to its normal working mode.
If the Man Down X is not put upright, it will continue to beep for 2 minutes. If this elapses, it will then trigger a man down alert in accordance
with your company’s escalation procedure, going to our ARC or to your company’s internal escalation.
Man Down X - Charging
3) Pin code request
Blue LED fast flashes (0.3 seconds on,
0.3 seconds off)
Low Battery
Start function to set a default length timer which is described in the
O.W.L Platform.
Custom function to create custom timers.
Cancel function to cancel currently set timers.
Select an option by speaking into the Man Down X when prompted, and
you will then be instructed by the automated voice on how to proceed.
Note: While the Man Down X is charging and the
power is on, the Man Down feature will be active -
to avoid false alarms, we recommend that you
switch your Man Down X off and it will continue to
charge.
If a switched off Man Down X is placed on charge, it
will power the Man Down X on - however, it can
then be turned off while it continues to charge.
Blue LED is solid when plugged in
Charging
To reach full power, we recommend that you leave your Man Down X charging for 3-4 hours.